Commit 6da15e96 authored by Guennadi Liakhovetski's avatar Guennadi Liakhovetski Committed by Chris Ball

mmc: detailed definition of CD and WP MMC line polarities in DT

Clarify ways to specify write-protect and card-detect MMC lines in FDT.
Signed-off-by: default avatarGuennadi Liakhovetski <g.liakhovetski@gmx.de>
Signed-off-by: default avatarChris Ball <cjb@laptop.org>
parent 7b952137
...@@ -17,12 +17,31 @@ Optional properties: ...@@ -17,12 +17,31 @@ Optional properties:
- bus-width: Number of data lines, can be <1>, <4>, or <8>. The default - bus-width: Number of data lines, can be <1>, <4>, or <8>. The default
will be <1> if the property is absent. will be <1> if the property is absent.
- wp-gpios: Specify GPIOs for write protection, see gpio binding - wp-gpios: Specify GPIOs for write protection, see gpio binding
- cd-inverted: when present, polarity on the cd gpio line is inverted - cd-inverted: when present, polarity on the CD line is inverted. See the note
- wp-inverted: when present, polarity on the wp gpio line is inverted below for the case, when a GPIO is used for the CD line
- wp-inverted: when present, polarity on the WP line is inverted. See the note
below for the case, when a GPIO is used for the WP line
- max-frequency: maximum operating clock frequency - max-frequency: maximum operating clock frequency
- no-1-8-v: when present, denotes that 1.8v card voltage is not supported on - no-1-8-v: when present, denotes that 1.8v card voltage is not supported on
this system, even if the controller claims it is. this system, even if the controller claims it is.
*NOTE* on CD and WP polarity. To use common for all SD/MMC host controllers line
polarity properties, we have to fix the meaning of the "normal" and "inverted"
line levels. We choose to follow the SDHCI standard, which specifies both those
lines as "active low." Therefore, using the "cd-inverted" property means, that
the CD line is active high, i.e. it is high, when a card is inserted. Similar
logic applies to the "wp-inverted" property.
CD and WP lines can be implemented on the hardware in one of two ways: as GPIOs,
specified in cd-gpios and wp-gpios properties, or as dedicated pins. Polarity of
dedicated pins can be specified, using *-inverted properties. GPIO polarity can
also be specified using the OF_GPIO_ACTIVE_LOW flag. This creates an ambiguity
in the latter case. We choose to use the XOR logic for GPIO CD and WP lines.
This means, the two properties are "superimposed," for example leaving the
OF_GPIO_ACTIVE_LOW flag clear and specifying the respective *-inverted
property results in a double-inversion and actually means the "normal" line
polarity is in effect.
Optional SDIO properties: Optional SDIO properties:
- keep-power-in-suspend: Preserves card power during a suspend/resume cycle - keep-power-in-suspend: Preserves card power during a suspend/resume cycle
- enable-sdio-wakeup: Enables wake up of host system on SDIO IRQ assertion - enable-sdio-wakeup: Enables wake up of host system on SDIO IRQ assertion
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment