Blackfin: bf537: rename ad2s120x ->ad2s1200

In v3.2 the Analog Devices ad2s1200/ad2s1205 driver was renamed from
ad2s120x to ad2s1200. But it apparently forgot to rename the references
to this driver in the BF537-STAMP code. Rename these now, and use the
IS_ENABLED() macro, while we're at it.
Signed-off-by: Paul Bolle <pebolle@tiscali.nl>

arch/blackfin/mach-bf537/boards/stamp.c

@@ -655,13 +655,13 @@ static struct bfin5xx_spi_chip ad2s90_spi_chip_info = {
 };
 #endif
 
-#if defined(CONFIG_AD2S120X) || defined(CONFIG_AD2S120X_MODULE)
-static unsigned short ad2s120x_platform_data[] = {
+#if IS_ENABLED(CONFIG_AD2S1200)
+static unsigned short ad2s1200_platform_data[] = {
 	/* used as SAMPLE and RDVEL */
 	GPIO_PF5, GPIO_PF6, 0
 };
 
-static struct bfin5xx_spi_chip ad2s120x_spi_chip_info = {
+static struct bfin5xx_spi_chip ad2s1200_spi_chip_info = {
 	.enable_dma = 0,
 };
 #endif
@@ -1019,13 +1019,13 @@ static struct spi_board_info bfin_spi_board_info[] __initdata = {
 	},
 #endif
 
-#if defined(CONFIG_AD2S120X) || defined(CONFIG_AD2S120X_MODULE)
+#if IS_ENABLED(CONFIG_AD2S1200)
 	{
-		.modalias = "ad2s120x",
+		.modalias = "ad2s1200",
 		.bus_num = 0,
 		.chip_select = 4,            /* CS, change it for your board */
-		.platform_data = ad2s120x_platform_data,
-		.controller_data = &ad2s120x_spi_chip_info,
+		.platform_data = ad2s1200_platform_data,
+		.controller_data = &ad2s1200_spi_chip_info,
 	},
 #endif