mac80211: when receiving DTIM disable power-save mode only if it was enabled

When receiving DTIM we currently disable power save mode in the
hardware unconditionally, i.e. also when the hardware was not sleeping.
This causes trouble with at least one wireless chipset (Ralink RT3572).
When the hardware is not sleeping and we send a wakeup command (e.g.
this happens after a scan) then a significant decrease of the link
quality or a disconnect may occur.
Disabling power save mode only when it was enabled prevents this issue.
Signed-off-by: Ronald Wahl <ronald.wahl@raritan.com>
Reviewed-by: Gertjan van Wingerde <gwingerde@gmail.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>

net/mac80211/mlme.c

@@ -2471,9 +2471,11 @@ static void ieee80211_rx_mgmt_beacon(struct ieee80211_sub_if_data *sdata,
 	if (local->hw.flags & IEEE80211_HW_PS_NULLFUNC_STACK) {
 		if (directed_tim) {
 			if (local->hw.conf.dynamic_ps_timeout > 0) {
-				local->hw.conf.flags &= ~IEEE80211_CONF_PS;
-				ieee80211_hw_config(local,
-						    IEEE80211_CONF_CHANGE_PS);
+				if (local->hw.conf.flags & IEEE80211_CONF_PS) {
+					local->hw.conf.flags &= ~IEEE80211_CONF_PS;
+					ieee80211_hw_config(local,
+							    IEEE80211_CONF_CHANGE_PS);
+				}
 				ieee80211_send_nullfunc(local, sdata, 0);
 			} else if (!local->pspolling && sdata->u.mgd.powersave) {
 				local->pspolling = true;