mac80211_hwsim: Update timestamp in Probe Response frames

Previously, this was done only for Beacon frames, but similar timestamp
update is needed for Probe Response frames to make these more accurately
match the real IEEE 802.11 behavior. Previously, all zeros timestamp was
sent in Probe Response frames.
Signed-off-by: Jouni Malinen <jouni@qca.qualcomm.com>
Signed-off-by: Johannes Berg <johannes.berg@intel.com>

drivers/net/wireless/mac80211_hwsim.c

@@ -1250,6 +1250,7 @@ static void mac80211_hwsim_tx(struct ieee80211_hw *hw,
 {
 	struct mac80211_hwsim_data *data = hw->priv;
 	struct ieee80211_tx_info *txi = IEEE80211_SKB_CB(skb);
+	struct ieee80211_hdr *hdr = (void *)skb->data;
 	struct ieee80211_chanctx_conf *chanctx_conf;
 	struct ieee80211_channel *channel;
 	bool ack;
@@ -1295,6 +1296,22 @@ static void mac80211_hwsim_tx(struct ieee80211_hw *hw,
 				       ARRAY_SIZE(txi->control.rates));
 
 	txi->rate_driver_data[0] = channel;
+
+	if (skb->len >= 24 + 8 &&
+	    ieee80211_is_probe_resp(hdr->frame_control)) {
+		/* fake header transmission time */
+		struct ieee80211_mgmt *mgmt;
+		struct ieee80211_rate *txrate;
+		u64 ts;
+
+		mgmt = (struct ieee80211_mgmt *)skb->data;
+		txrate = ieee80211_get_tx_rate(hw, txi);
+		ts = mac80211_hwsim_get_tsf_raw();
+		mgmt->u.probe_resp.timestamp =
+			cpu_to_le64(ts + data->tsf_offset +
+				    24 * 8 * 10 / txrate->bitrate);
+	}
+
 	mac80211_hwsim_monitor_rx(hw, skb, channel);
 
 	/* wmediumd mode check */