Commit 7711308a authored by Mark Brown's avatar Mark Brown

ASoC: Implement interrupt based jack detection

Allow microphone detection on WM8962 to be performed using the interrupt
signal, allowing the detection of both microphone presence and button
presses with a signal singal from the CODEC to CPU.  Currently a 250ms
debounce time is applied to both short circuit and presence detection,
this has not been optimised.
Signed-off-by: default avatarMark Brown <broonie@opensource.wolfsonmicro.com>
Acked-by: default avatarLiam Girdwood <lrg@slimlogic.co.uk>
parent 3367b8d4
......@@ -25,6 +25,7 @@
#include <linux/slab.h>
#include <linux/workqueue.h>
#include <sound/core.h>
#include <sound/jack.h>
#include <sound/pcm.h>
#include <sound/pcm_params.h>
#include <sound/soc.h>
......@@ -63,6 +64,9 @@ struct wm8962_priv {
int fll_fref;
int fll_fout;
struct delayed_work mic_work;
struct snd_soc_jack *jack;
struct regulator_bulk_data supplies[WM8962_NUM_SUPPLIES];
struct notifier_block disable_nb[WM8962_NUM_SUPPLIES];
......@@ -1462,9 +1466,40 @@ static struct snd_soc_dai_driver wm8962_dai = {
.symmetric_rates = 1,
};
static void wm8962_mic_work(struct work_struct *work)
{
struct wm8962_priv *wm8962 = container_of(work,
struct wm8962_priv,
mic_work.work);
struct snd_soc_codec *codec = wm8962->codec;
int status = 0;
int irq_pol = 0;
int reg;
reg = snd_soc_read(codec, WM8962_ADDITIONAL_CONTROL_4);
if (reg & WM8962_MICDET_STS) {
status |= SND_JACK_MICROPHONE;
irq_pol |= WM8962_MICD_IRQ_POL;
}
if (reg & WM8962_MICSHORT_STS) {
status |= SND_JACK_BTN_0;
irq_pol |= WM8962_MICSCD_IRQ_POL;
}
snd_soc_jack_report(wm8962->jack, status,
SND_JACK_MICROPHONE | SND_JACK_BTN_0);
snd_soc_update_bits(codec, WM8962_MICINT_SOURCE_POL,
WM8962_MICSCD_IRQ_POL |
WM8962_MICD_IRQ_POL, irq_pol);
}
static irqreturn_t wm8962_irq(int irq, void *data)
{
struct snd_soc_codec *codec = data;
struct wm8962_priv *wm8962 = snd_soc_codec_get_drvdata(codec);
int mask;
int active;
......@@ -1479,12 +1514,59 @@ static irqreturn_t wm8962_irq(int irq, void *data)
if (active & WM8962_TEMP_SHUT_EINT)
dev_crit(codec->dev, "Thermal shutdown\n");
if (active & (WM8962_MICSCD_EINT | WM8962_MICD_EINT)) {
dev_dbg(codec->dev, "Microphone event detected\n");
schedule_delayed_work(&wm8962->mic_work,
msecs_to_jiffies(250));
}
/* Acknowledge the interrupts */
snd_soc_write(codec, WM8962_INTERRUPT_STATUS_2, active);
return IRQ_HANDLED;
}
/**
* wm8962_mic_detect - Enable microphone detection via the WM8962 IRQ
*
* @codec: WM8962 codec
* @jack: jack to report detection events on
*
* Enable microphone detection via IRQ on the WM8962. If GPIOs are
* being used to bring out signals to the processor then only platform
* data configuration is needed for WM8962 and processor GPIOs should
* be configured using snd_soc_jack_add_gpios() instead.
*
* If no jack is supplied detection will be disabled.
*/
int wm8962_mic_detect(struct snd_soc_codec *codec, struct snd_soc_jack *jack)
{
struct wm8962_priv *wm8962 = snd_soc_codec_get_drvdata(codec);
int irq_mask, enable;
wm8962->jack = jack;
if (jack) {
irq_mask = 0;
enable = WM8962_MICDET_ENA;
} else {
irq_mask = WM8962_MICD_EINT | WM8962_MICSCD_EINT;
enable = 0;
}
snd_soc_update_bits(codec, WM8962_INTERRUPT_STATUS_2_MASK,
WM8962_MICD_EINT | WM8962_MICSCD_EINT, irq_mask);
snd_soc_update_bits(codec, WM8962_ADDITIONAL_CONTROL_4,
WM8962_MICDET_ENA, enable);
/* Send an initial empty report */
snd_soc_jack_report(wm8962->jack, 0,
SND_JACK_MICROPHONE | SND_JACK_BTN_0);
return 0;
}
EXPORT_SYMBOL_GPL(wm8962_mic_detect);
#ifdef CONFIG_PM
static int wm8962_resume(struct snd_soc_codec *codec)
{
......@@ -1773,6 +1855,7 @@ static int wm8962_probe(struct snd_soc_codec *codec)
int i, trigger, irq_pol;
wm8962->codec = codec;
INIT_DELAYED_WORK(&wm8962->mic_work, wm8962_mic_work);
codec->cache_sync = 1;
codec->idle_bias_off = 1;
......@@ -1946,6 +2029,8 @@ static int wm8962_remove(struct snd_soc_codec *codec)
if (i2c->irq)
free_irq(i2c->irq, codec);
cancel_delayed_work_sync(&wm8962->mic_work);
wm8962_free_gpio(codec);
wm8962_free_beep(codec);
for (i = 0; i < ARRAY_SIZE(wm8962->supplies); i++)
......
......@@ -14,6 +14,7 @@
#define _WM8962_H
#include <asm/types.h>
#include <sound/soc.h>
#define WM8962_SYSCLK_MCLK 1
#define WM8962_SYSCLK_FLL 2
......@@ -3785,4 +3786,6 @@ struct wm8962_reg_access {
extern
const struct wm8962_reg_access wm8962_reg_access[WM8962_MAX_REGISTER + 1];
int wm8962_mic_detect(struct snd_soc_codec *codec, struct snd_soc_jack *jack);
#endif
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment