Commit 7a883eaf authored by Linus Torvalds's avatar Linus Torvalds

Merge git://git.infradead.org/~dwmw2/mtd-2.6.23

* git://git.infradead.org/~dwmw2/mtd-2.6.23:
  [MTD] [NAND] nand_base.c: fix type of eccpos pointer
  [MTD] [NAND] at91_nand rdy_pin fix
  [MTD] [NAND] fix race in nand_base.c
  [MTD] [NAND] Fix refactoring of EDB7312 hwcontrol function.
  [MTD] Fix potential leak in rfd_ftl_add_mtd
  [JFFS2] Print correct node offset when complaining about broken data CRC
  [JFFS2] Fix suspend failure with JFFS2 GC thread.
  [JFFS2] Deletion dirents should be REF_NORMAL, not REF_PRISTINE.
  [JFFS2] Prevent oops after 'node added in wrong place' debug check
parents 628506c8 515495a1
......@@ -128,7 +128,10 @@ static int __init at91_nand_probe(struct platform_device *pdev)
nand_chip->IO_ADDR_R = host->io_base;
nand_chip->IO_ADDR_W = host->io_base;
nand_chip->cmd_ctrl = at91_nand_cmd_ctrl;
nand_chip->dev_ready = at91_nand_device_ready;
if (host->board->rdy_pin)
nand_chip->dev_ready = at91_nand_device_ready;
nand_chip->ecc.mode = NAND_ECC_SOFT; /* enable ECC */
nand_chip->chip_delay = 20; /* 20us command delay time */
......
......@@ -74,7 +74,7 @@ static struct mtd_partition partition_info[] = {
/*
* hardware specific access to control-lines
*
* NAND_NCE: bit 0 -> bit 7
* NAND_NCE: bit 0 -> bit 6 (bit 7 = 1)
* NAND_CLE: bit 1 -> bit 4
* NAND_ALE: bit 2 -> bit 5
*/
......@@ -83,12 +83,12 @@ static void ep7312_hwcontrol(struct mtd_info *mtd, int cmd, unsigned int ctrl)
struct nand_chip *chip = mtd->priv;
if (ctrl & NAND_CTRL_CHANGE) {
unsigned char bits;
unsigned char bits = 0x80;
bits = (ctrl & (NAND_CLE | NAND_ALE)) << 3;
bits = (ctrl & NAND_NCE) << 7;
bits |= (ctrl & (NAND_CLE | NAND_ALE)) << 3;
bits |= (ctrl & NAND_NCE) ? 0x00 : 0x40;
clps_writeb((clps_readb(ep7312_pxdr) & 0xB0) | 0x10,
clps_writeb((clps_readb(ep7312_pxdr) & 0xF0) | bits,
ep7312_pxdr);
}
if (cmd != NAND_CMD_NONE)
......
......@@ -24,6 +24,7 @@
* if we have HW ecc support.
* The AG-AND chips have nice features for speed improvement,
* which are not supported yet. Read / program 4 pages in one go.
* BBT table is not serialized, has to be fixed
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License version 2 as
......@@ -360,6 +361,7 @@ static int nand_default_block_markbad(struct mtd_info *mtd, loff_t ofs)
/* We write two bytes, so we dont have to mess with 16 bit
* access
*/
nand_get_device(chip, mtd, FL_WRITING);
ofs += mtd->oobsize;
chip->ops.len = chip->ops.ooblen = 2;
chip->ops.datbuf = NULL;
......@@ -367,9 +369,11 @@ static int nand_default_block_markbad(struct mtd_info *mtd, loff_t ofs)
chip->ops.ooboffs = chip->badblockpos & ~0x01;
ret = nand_do_write_oob(mtd, ofs, &chip->ops);
nand_release_device(mtd);
}
if (!ret)
mtd->ecc_stats.badblocks++;
return ret;
}
......@@ -768,7 +772,7 @@ static int nand_read_page_swecc(struct mtd_info *mtd, struct nand_chip *chip,
uint8_t *p = buf;
uint8_t *ecc_calc = chip->buffers->ecccalc;
uint8_t *ecc_code = chip->buffers->ecccode;
int *eccpos = chip->ecc.layout->eccpos;
uint32_t *eccpos = chip->ecc.layout->eccpos;
chip->ecc.read_page_raw(mtd, chip, buf);
......@@ -810,7 +814,7 @@ static int nand_read_page_hwecc(struct mtd_info *mtd, struct nand_chip *chip,
uint8_t *p = buf;
uint8_t *ecc_calc = chip->buffers->ecccalc;
uint8_t *ecc_code = chip->buffers->ecccode;
int *eccpos = chip->ecc.layout->eccpos;
uint32_t *eccpos = chip->ecc.layout->eccpos;
for (i = 0; eccsteps; eccsteps--, i += eccbytes, p += eccsize) {
chip->ecc.hwctl(mtd, NAND_ECC_READ);
......@@ -1416,7 +1420,7 @@ static void nand_write_page_swecc(struct mtd_info *mtd, struct nand_chip *chip,
int eccsteps = chip->ecc.steps;
uint8_t *ecc_calc = chip->buffers->ecccalc;
const uint8_t *p = buf;
int *eccpos = chip->ecc.layout->eccpos;
uint32_t *eccpos = chip->ecc.layout->eccpos;
/* Software ecc calculation */
for (i = 0; eccsteps; eccsteps--, i += eccbytes, p += eccsize)
......@@ -1442,7 +1446,7 @@ static void nand_write_page_hwecc(struct mtd_info *mtd, struct nand_chip *chip,
int eccsteps = chip->ecc.steps;
uint8_t *ecc_calc = chip->buffers->ecccalc;
const uint8_t *p = buf;
int *eccpos = chip->ecc.layout->eccpos;
uint32_t *eccpos = chip->ecc.layout->eccpos;
for (i = 0; eccsteps; eccsteps--, i += eccbytes, p += eccsize) {
chip->ecc.hwctl(mtd, NAND_ECC_WRITE);
......
......@@ -779,6 +779,7 @@ static void rfd_ftl_add_mtd(struct mtd_blktrans_ops *tr, struct mtd_info *mtd)
else {
if (!mtd->erasesize) {
printk(KERN_WARNING PREFIX "please provide block_size");
kfree(part);
return;
}
else
......
......@@ -84,7 +84,7 @@ static int jffs2_garbage_collect_thread(void *_c)
set_freezable();
for (;;) {
allow_signal(SIGHUP);
again:
if (!jffs2_thread_should_wake(c)) {
set_current_state (TASK_INTERRUPTIBLE);
D1(printk(KERN_DEBUG "jffs2_garbage_collect_thread sleeping...\n"));
......@@ -95,9 +95,6 @@ static int jffs2_garbage_collect_thread(void *_c)
schedule();
}
if (try_to_freeze())
continue;
/* This thread is purely an optimisation. But if it runs when
other things could be running, it actually makes things a
lot worse. Use yield() and put it at the back of the runqueue
......@@ -112,6 +109,9 @@ static int jffs2_garbage_collect_thread(void *_c)
siginfo_t info;
unsigned long signr;
if (try_to_freeze())
goto again;
signr = dequeue_signal_lock(current, &current->blocked, &info);
switch(signr) {
......
......@@ -139,6 +139,11 @@ static inline struct jffs2_inode_cache *jffs2_raw_ref_to_ic(struct jffs2_raw_nod
#define ref_obsolete(ref) (((ref)->flash_offset & 3) == REF_OBSOLETE)
#define mark_ref_normal(ref) do { (ref)->flash_offset = ref_offset(ref) | REF_NORMAL; } while(0)
/* Dirent nodes should be REF_PRISTINE only if they are not a deletion
dirent. Deletion dirents should be REF_NORMAL so that GC gets to
throw them away when appropriate */
#define dirent_node_state(rd) ( (je32_to_cpu((rd)->ino)?REF_PRISTINE:REF_NORMAL) )
/* NB: REF_PRISTINE for an inode-less node (ref->next_in_ino == NULL) indicates
it is an unknown node of type JFFS2_NODETYPE_RWCOMPAT_COPY, so it'll get
copied. If you need to do anything different to GC inode-less nodes, then
......
......@@ -104,7 +104,7 @@ static int check_node_data(struct jffs2_sb_info *c, struct jffs2_tmp_dnode_info
if (crc != tn->data_crc) {
JFFS2_NOTICE("wrong data CRC in data node at 0x%08x: read %#08x, calculated %#08x.\n",
ofs, tn->data_crc, crc);
ref_offset(ref), tn->data_crc, crc);
return 1;
}
......@@ -613,7 +613,7 @@ static inline int read_direntry(struct jffs2_sb_info *c, struct jffs2_raw_node_r
jeb->unchecked_size -= len;
c->used_size += len;
c->unchecked_size -= len;
ref->flash_offset = ref_offset(ref) | REF_PRISTINE;
ref->flash_offset = ref_offset(ref) | dirent_node_state(rd);
spin_unlock(&c->erase_completion_lock);
}
......
......@@ -1049,7 +1049,8 @@ static int jffs2_scan_dirent_node(struct jffs2_sb_info *c, struct jffs2_eraseblo
return -ENOMEM;
}
fd->raw = jffs2_link_node_ref(c, jeb, ofs | REF_PRISTINE, PAD(je32_to_cpu(rd->totlen)), ic);
fd->raw = jffs2_link_node_ref(c, jeb, ofs | dirent_node_state(rd),
PAD(je32_to_cpu(rd->totlen)), ic);
fd->next = NULL;
fd->version = je32_to_cpu(rd->version);
......
......@@ -173,6 +173,12 @@ struct jffs2_full_dnode *jffs2_write_dnode(struct jffs2_sb_info *c, struct jffs2
flash_ofs |= REF_NORMAL;
}
fn->raw = jffs2_add_physical_node_ref(c, flash_ofs, PAD(sizeof(*ri)+datalen), f->inocache);
if (IS_ERR(fn->raw)) {
void *hold_err = fn->raw;
/* Release the full_dnode which is now useless, and return */
jffs2_free_full_dnode(fn);
return ERR_PTR(PTR_ERR(hold_err));
}
fn->ofs = je32_to_cpu(ri->offset);
fn->size = je32_to_cpu(ri->dsize);
fn->frags = 0;
......@@ -290,7 +296,14 @@ struct jffs2_full_dirent *jffs2_write_dirent(struct jffs2_sb_info *c, struct jff
return ERR_PTR(ret?ret:-EIO);
}
/* Mark the space used */
fd->raw = jffs2_add_physical_node_ref(c, flash_ofs | REF_PRISTINE, PAD(sizeof(*rd)+namelen), f->inocache);
fd->raw = jffs2_add_physical_node_ref(c, flash_ofs | dirent_node_state(rd),
PAD(sizeof(*rd)+namelen), f->inocache);
if (IS_ERR(fd->raw)) {
void *hold_err = fd->raw;
/* Release the full_dirent which is now useless, and return */
jffs2_free_full_dirent(fd);
return ERR_PTR(PTR_ERR(hold_err));
}
if (retried) {
jffs2_dbg_acct_sanity_check(c,NULL);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment