ixgbe: Make FCoE allocation and configuration closer to how rings work
This patch changes the behavior of the FCoE configuration so that it is much closer to how the main body of the ixgbe driver works for ring allocation. The first piece is the ixgbe_fcoe_ddp_enable/disable calls. These allocate the percpu values and if successful set the fcoe_ddp_xid value indicating that we can support DDP. The next piece is the ixgbe_setup/free_ddp_resources calls. These are called on open/close and will allocate and free the DMA pools. Finally ixgbe_configure_fcoe is now just register configuration. It can go through and enable the registers for the FCoE redirection offload, and FIP configuration without any interference from the DDP pool allocation. The net result of all this is two fold. First it adds a certain amount of exception handling. So for example if ixgbe_setup_fcoe_resources fails we will actually generate an error in open and refuse to bring up the interface. Secondly it provides a much more graceful failure case than the previous model which would skip setting up the registers for FCoE on failure to allocate DDP resources leaving no Rx functionality enabled instead of just disabling DDP. Signed-off-by: Alexander Duyck <alexander.h.duyck@intel.com> Tested-by: Phil Schmitt <phillip.j.schmitt@intel.com> Tested-by: Ross Brattain <ross.b.brattain@intel.com> Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
Showing
Please register or sign in to comment