drm/sun4i: tcon: Prepare and enable TCON channel 0 clock at init

[ Upstream commit b14e945b ]

When initializing clocks, a reference to the TCON channel 0 clock is
obtained. However, the clock is never prepared and enabled later.
Switching from simplefb to DRM actually disables the clock (that was
usually configured by U-Boot) because of that.

On the V3s, this results in a hang when writing to some mixer registers
when switching over to DRM from simplefb.

Fix this by preparing and enabling the clock when initializing other
clocks. Waiting for sun4i_tcon_channel_enable to enable the clock is
apparently too late and results in the same mixer register access hang.
Signed-off-by: Paul Kocialkowski <paul.kocialkowski@bootlin.com>
Signed-off-by: Maxime Ripard <maxime.ripard@bootlin.com>
Link: https://patchwork.freedesktop.org/patch/msgid/20190131132550.26355-1-paul.kocialkowski@bootlin.comSigned-off-by: Sasha Levin <sashal@kernel.org>

drivers/gpu/drm/sun4i/sun4i_tcon.c

@@ -672,6 +672,7 @@ static int sun4i_tcon_init_clocks(struct device *dev,
 			return PTR_ERR(tcon->sclk0);
 		}
 	}
+	clk_prepare_enable(tcon->sclk0);
 
 	if (tcon->quirks->has_channel_1) {
 		tcon->sclk1 = devm_clk_get(dev, "tcon-ch1");
@@ -686,6 +687,7 @@ static int sun4i_tcon_init_clocks(struct device *dev,
 
 static void sun4i_tcon_free_clocks(struct sun4i_tcon *tcon)
 {
+	clk_disable_unprepare(tcon->sclk0);
 	clk_disable_unprepare(tcon->clk);
 }