tty: serial: samsung: Correct clock selection logic

Some variants of the samsung tty driver can pick which clock
to use for their baud rate generation.  In the DT conversion,
a default clock was selected to be used if a specific one wasn't
assigned and then a comparison of which clock rate worked better
was done.  Unfortunately, the comparison was implemented in such
a way that only the default clock was ever actually compared.
Fix this by iterating through all possible clocks, except when a
specific clock has already been picked via clk_sel (which is
only possible via board files).
Signed-off-by: Jonathan Bakker <xc-racer2@live.ca>
Reviewed-by: Krzysztof Kozlowski <krzk@kernel.org>
Link: https://lore.kernel.org/r/BN6PR04MB06604E63833EA41837EBF77BA3A30@BN6PR04MB0660.namprd04.prod.outlook.comSigned-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/tty/serial/samsung_tty.c

@@ -1304,14 +1304,14 @@ static unsigned int s3c24xx_serial_getclk(struct s3c24xx_uart_port *ourport,
 	struct s3c24xx_uart_info *info = ourport->info;
 	struct clk *clk;
 	unsigned long rate;
-	unsigned int cnt, baud, quot, clk_sel, best_quot = 0;
+	unsigned int cnt, baud, quot, best_quot = 0;
 	char clkname[MAX_CLK_NAME_LENGTH];
 	int calc_deviation, deviation = (1 << 30) - 1;
 
-	clk_sel = (ourport->cfg->clk_sel) ? ourport->cfg->clk_sel :
-			ourport->info->def_clk_sel;
 	for (cnt = 0; cnt < info->num_clks; cnt++) {
-		if (!(clk_sel & (1 << cnt)))
+		/* Keep selected clock if provided */
+		if (ourport->cfg->clk_sel &&
+			!(ourport->cfg->clk_sel & (1 << cnt)))
 			continue;
 
 		sprintf(clkname, "clk_uart_baud%d", cnt);