Merge branch 'spi-tegra' into spi-next

Documentation/devicetree/bindings/spi/nvidia,tegra20-sflash.txt

+NVIDIA Tegra20 SFLASH controller.
+
+Required properties:
+- compatible : should be "nvidia,tegra20-sflash".
+- reg: Should contain SFLASH registers location and length.
+- interrupts: Should contain SFLASH interrupts.
+- nvidia,dma-request-selector : The Tegra DMA controller's phandle and
+  request selector for this SFLASH controller.
+
+Recommended properties:
+- spi-max-frequency: Definition as per
+                     Documentation/devicetree/bindings/spi/spi-bus.txt
+
+Example:
+
+spi@7000d600 {
+	compatible = "nvidia,tegra20-sflash";
+	reg = <0x7000c380 0x80>;
+	interrupts = <0 39 0x04>;
+	nvidia,dma-request-selector = <&apbdma 16>;
+	spi-max-frequency = <25000000>;
+	#address-cells = <1>;
+	#size-cells = <0>;
+	status = "disabled";
+};
+

drivers/spi/Kconfig

@@ -385,6 +385,14 @@ config SPI_MXS
 	help
 	  SPI driver for Freescale MXS devices.
 
+config SPI_TEGRA20_SFLASH
+	tristate "Nvidia Tegra20 Serial flash Controller"
+	depends on ARCH_TEGRA
+	help
+	  SPI driver for Nvidia Tegra20 Serial flash Controller interface.
+	  The main usecase of this controller is to use spi flash as boot
+	  device.
+
 config SPI_TEGRA20_SLINK
 	tristate "Nvidia Tegra20/Tegra30 SLINK Controller"
 	depends on ARCH_TEGRA && TEGRA20_APB_DMA

drivers/spi/Makefile

@@ -60,6 +60,7 @@ obj-$(CONFIG_SPI_SH_MSIOF)		+= spi-sh-msiof.o
 obj-$(CONFIG_SPI_SH_SCI)		+= spi-sh-sci.o
 obj-$(CONFIG_SPI_SIRF)		+= spi-sirf.o
 obj-$(CONFIG_SPI_STMP3XXX)		+= spi-stmp.o
+obj-$(CONFIG_SPI_TEGRA20_SFLASH)	+= spi-tegra20-sflash.o
 obj-$(CONFIG_SPI_TEGRA20_SLINK)		+= spi-tegra20-slink.o
 obj-$(CONFIG_SPI_TI_SSP)		+= spi-ti-ssp.o
 obj-$(CONFIG_SPI_TLE62X0)		+= spi-tle62x0.o