Commit 82960fff authored by Jisheng Zhang's avatar Jisheng Zhang Committed by David S. Miller

net: mvneta: fix failed to suspend if WOL is enabled

Recently, suspend/resume and WOL support are added into mvneta driver.
If we enable WOL, then we get some error as below on Marvell BG4CT
platforms during suspend:

[  184.149723] dpm_run_callback(): mdio_bus_suspend+0x0/0x50 returns -16
[  184.149727] PM: Device f7b62004.mdio-mi:00 failed to suspend: error -16

-16 means -EBUSY, phy_suspend() will return -EBUSY if it finds the
device has WOL enabled.

We fix this issue by properly setting the netdev's power.can_wakeup
and power.wakeup, i.e

1. in mvneta_mdio_probe(), call device_set_wakeup_capable() to set
power.can_wakeup if the phy support WOL.

2. in mvneta_ethtool_set_wol(), call device_set_wakeup_enable() to
set power.wakeup if WOL has been successfully enabled in phy.
Signed-off-by: default avatarJisheng Zhang <jszhang@marvell.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent cab93af0
......@@ -3318,6 +3318,7 @@ static void mvneta_adjust_link(struct net_device *ndev)
static int mvneta_mdio_probe(struct mvneta_port *pp)
{
struct phy_device *phy_dev;
struct ethtool_wolinfo wol = { .cmd = ETHTOOL_GWOL };
phy_dev = of_phy_connect(pp->dev, pp->phy_node, mvneta_adjust_link, 0,
pp->phy_interface);
......@@ -3326,6 +3327,9 @@ static int mvneta_mdio_probe(struct mvneta_port *pp)
return -ENODEV;
}
phy_ethtool_get_wol(phy_dev, &wol);
device_set_wakeup_capable(&pp->dev->dev, !!wol.supported);
phy_dev->supported &= PHY_GBIT_FEATURES;
phy_dev->advertising = phy_dev->supported;
......@@ -3942,10 +3946,16 @@ static void mvneta_ethtool_get_wol(struct net_device *dev,
static int mvneta_ethtool_set_wol(struct net_device *dev,
struct ethtool_wolinfo *wol)
{
int ret;
if (!dev->phydev)
return -EOPNOTSUPP;
return phy_ethtool_set_wol(dev->phydev, wol);
ret = phy_ethtool_set_wol(dev->phydev, wol);
if (!ret)
device_set_wakeup_enable(&dev->dev, !!wol->wolopts);
return ret;
}
static const struct net_device_ops mvneta_netdev_ops = {
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment