brcmfmac: get chip's default RAM info during PCIe setup

Getting RAM info just once per driver's lifetime (during chip
recognition) is not enough as it may get adjusted later (depending on
the used firmware). Subsequent inits may load different firmwares so a
full RAM recognition is required on every PCIe setup. This is especially
important since implementing hardware reset on a firmware crash.

Moreover calling brcmf_chip_get_raminfo() makes sure that RAM core is
up. It's important as having BCMA_CORE_SYS_MEM down on BCM4366 was
resulting in firmware failing to initialize and following error:
[   65.657546] brcmfmac 0000:01:00.0: brcmf_pcie_download_fw_nvram: Invalid shared RAM address 0x04000001

This change makes brcmf_chip_get_raminfo() call during chip recognition
redundant for PCIe devices but SDIO and USB still need it and it's a
very small overhead anyway.

Fixes: 4684997d ("brcmfmac: reset PCIe bus on a firmware crash")
Signed-off-by: Rafał Miłecki <rafal@milecki.pl>
Signed-off-by: Kalle Valo <kvalo@codeaurora.org>

drivers/net/wireless/broadcom/brcm80211/brcmfmac/chip.c

@@ -696,8 +696,10 @@ static u32 brcmf_chip_tcm_rambase(struct brcmf_chip_priv *ci)
 	return 0;
 }
 
-static int brcmf_chip_get_raminfo(struct brcmf_chip_priv *ci)
+int brcmf_chip_get_raminfo(struct brcmf_chip *pub)
 {
+	struct brcmf_chip_priv *ci = container_of(pub, struct brcmf_chip_priv,
+						  pub);
 	struct brcmf_core_priv *mem_core;
 	struct brcmf_core *mem;
 
@@ -979,7 +981,7 @@ static int brcmf_chip_recognition(struct brcmf_chip_priv *ci)
 		brcmf_chip_set_passive(&ci->pub);
 	}
 
-	return brcmf_chip_get_raminfo(ci);
+	return brcmf_chip_get_raminfo(&ci->pub);
 }
 
 static void brcmf_chip_disable_arm(struct brcmf_chip_priv *chip, u16 id)

drivers/net/wireless/broadcom/brcm80211/brcmfmac/chip.h

@@ -69,6 +69,7 @@ struct brcmf_buscore_ops {
 	void (*activate)(void *ctx, struct brcmf_chip *chip, u32 rstvec);
 };
 
+int brcmf_chip_get_raminfo(struct brcmf_chip *pub);
 struct brcmf_chip *brcmf_chip_attach(void *ctx,
 				     const struct brcmf_buscore_ops *ops);
 void brcmf_chip_detach(struct brcmf_chip *chip);

drivers/net/wireless/broadcom/brcm80211/brcmfmac/pcie.c

@@ -1770,6 +1770,12 @@ static void brcmf_pcie_setup(struct device *dev, int ret,
 	nvram_len = fwreq->items[BRCMF_PCIE_FW_NVRAM].nv_data.len;
 	kfree(fwreq);
 
+	ret = brcmf_chip_get_raminfo(devinfo->ci);
+	if (ret) {
+		brcmf_err(bus, "Failed to get RAM info\n");
+		goto fail;
+	}
+
 	/* Some of the firmwares have the size of the memory of the device
 	 * defined inside the firmware. This is because part of the memory in
 	 * the device is shared and the devision is determined by FW. Parse