dl2k: convert to net_device_ops

Convert driver to new net_device_ops. Compile tested only.
Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/dl2k.c

@@ -85,6 +85,19 @@ static int mii_write (struct net_device *dev, int phy_addr, int reg_num,
 
 static const struct ethtool_ops ethtool_ops;
 
+static const struct net_device_ops netdev_ops = {
+	.ndo_open		= rio_open,
+	.ndo_start_xmit	= start_xmit,
+	.ndo_stop		= rio_close,
+	.ndo_get_stats		= get_stats,
+	.ndo_validate_addr	= eth_validate_addr,
+	.ndo_set_mac_address 	= eth_mac_addr,
+	.ndo_set_multicast_list = set_multicast,
+	.ndo_do_ioctl		= rio_ioctl,
+	.ndo_tx_timeout		= rio_tx_timeout,
+	.ndo_change_mtu		= change_mtu,
+};
+
 static int __devinit
 rio_probe1 (struct pci_dev *pdev, const struct pci_device_id *ent)
 {
@@ -197,15 +210,8 @@ rio_probe1 (struct pci_dev *pdev, const struct pci_device_id *ent)
 		else if (tx_coalesce > TX_RING_SIZE-1)
 			tx_coalesce = TX_RING_SIZE - 1;
 	}
-	dev->open = &rio_open;
-	dev->hard_start_xmit = &start_xmit;
-	dev->stop = &rio_close;
-	dev->get_stats = &get_stats;
-	dev->set_multicast_list = &set_multicast;
-	dev->do_ioctl = &rio_ioctl;
-	dev->tx_timeout = &rio_tx_timeout;
+	dev->netdev_ops = &netdev_ops;
 	dev->watchdog_timeo = TX_TIMEOUT;
-	dev->change_mtu = &change_mtu;
 	SET_ETHTOOL_OPS(dev, &ethtool_ops);
 #if 0
 	dev->features = NETIF_F_IP_CSUM;