ARM: dts: stm32: add cd-gpios properties for SD-cards on STM32MP1 boards

The broken-cd properties are replaced with cd-gpios, with the correct
GPIO to detect the card insertion. The GPIO lines require a pull-up.
Signed-off-by: Yann Gautier <yann.gautier@st.com>
Signed-off-by: Alexandre Torgue <alexandre.torgue@st.com>

arch/arm/boot/dts/stm32mp157a-avenger96.dts

@@ -292,7 +292,7 @@ &sdmmc1 {
 	pinctrl-0 = <&sdmmc1_b4_pins_a &sdmmc1_dir_pins_a>;
 	pinctrl-1 = <&sdmmc1_b4_od_pins_a>;
 	pinctrl-2 = <&sdmmc1_b4_sleep_pins_a>;
-	broken-cd;
+	cd-gpios = <&gpioi 8 (GPIO_ACTIVE_LOW | GPIO_PULL_UP)>;
 	st,sig-dir;
 	st,neg-edge;
 	st,use-ckin;

arch/arm/boot/dts/stm32mp157c-ed1.dts

@@ -312,7 +312,7 @@ &sdmmc1 {
 	pinctrl-0 = <&sdmmc1_b4_pins_a &sdmmc1_dir_pins_a>;
 	pinctrl-1 = <&sdmmc1_b4_od_pins_a &sdmmc1_dir_pins_a>;
 	pinctrl-2 = <&sdmmc1_b4_sleep_pins_a &sdmmc1_dir_sleep_pins_a>;
-	broken-cd;
+	cd-gpios = <&gpiog 1 (GPIO_ACTIVE_LOW | GPIO_PULL_UP)>;
 	st,sig-dir;
 	st,neg-edge;
 	st,use-ckin;

arch/arm/boot/dts/stm32mp15xx-dkx.dtsi

@@ -478,7 +478,7 @@ &sdmmc1 {
 	pinctrl-0 = <&sdmmc1_b4_pins_a>;
 	pinctrl-1 = <&sdmmc1_b4_od_pins_a>;
 	pinctrl-2 = <&sdmmc1_b4_sleep_pins_a>;
-	broken-cd;
+	cd-gpios = <&gpiob 7 (GPIO_ACTIVE_LOW | GPIO_PULL_UP)>;
 	st,neg-edge;
 	bus-width = <4>;
 	vmmc-supply = <&v3v3>;