Commit 89613e66 authored by Sergei Shtylyov's avatar Sergei Shtylyov Committed by Bartlomiej Zolnierkiewicz

ide: don't set PIO mode on pre-EIDE drives

Fix handling of the PIO modes for the pre-EIDE drives that did not support
the PIO Flow Control Transfer Mode value (00001 nnn) of the Set Transfer Mode
feature by skipping the actual mode programming.
Signed-off-by: default avatarSergei Shtylyov <sshtylyov@ru.mvista.com>
Signed-off-by: default avatarBartlomiej Zolnierkiewicz <bzolnier@gmail.com>
parent a1d85864
......@@ -756,7 +756,7 @@ int ide_driveid_update(ide_drive_t *drive)
int ide_config_drive_speed(ide_drive_t *drive, u8 speed)
{
ide_hwif_t *hwif = drive->hwif;
int error;
int error = 0;
u8 stat;
// while (HWGROUP(drive)->busy)
......@@ -767,6 +767,10 @@ int ide_config_drive_speed(ide_drive_t *drive, u8 speed)
hwif->dma_host_off(drive);
#endif
/* Skip setting PIO flow-control modes on pre-EIDE drives */
if ((speed & 0xf8) == XFER_PIO_0 && !(drive->id->capability & 0x08))
goto skip;
/*
* Don't use ide_wait_cmd here - it will
* attempt to set_geometry and recalibrate,
......@@ -814,6 +818,7 @@ int ide_config_drive_speed(ide_drive_t *drive, u8 speed)
drive->id->dma_mword &= ~0x0F00;
drive->id->dma_1word &= ~0x0F00;
skip:
#ifdef CONFIG_BLK_DEV_IDEDMA
if (speed >= XFER_SW_DMA_0)
hwif->dma_host_on(drive);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment