[PATCH] ppc32: Remove board support for MCPN765

Support for the MCPN765 board is no longer maintained and thus being removed
Signed-off-by: Kumar Gala <kumar.gala@freescale.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

arch/ppc/Kconfig

@@ -613,9 +613,6 @@ config EV64260
 config LOPEC
 	bool "Motorola-LoPEC"
 
-config MCPN765
-	bool "Motorola-MCPN765"
-
 config MVME5100
 	bool "Motorola-MVME5100"
 
@@ -790,7 +787,7 @@ config PPC_OF
 
 config PPC_GEN550
 	bool
-	depends on SANDPOINT || MCPN765 || SPRUCE || PPLUS || PCORE || \
+	depends on SANDPOINT || SPRUCE || PPLUS || PCORE || \
 		PRPMC750 || PRPMC800 || LOPEC || \
 		(EV64260 && !SERIAL_MPSC) || CHESTNUT || RADSTONE_PPC7D || \
 		83xx

arch/ppc/boot/simple/Makefile

@@ -106,7 +106,7 @@ zimageinitrd-$(CONFIG_GEMINI)		:= zImage.initrd-STRIPELF
 
 # kconfig 'feature', only one of these will ever be 'y' at a time.
 # The rest will be unset.
-motorola := $(CONFIG_MCPN765)$(CONFIG_MVME5100)$(CONFIG_PRPMC750) \
+motorola := $(CONFIG_MVME5100)$(CONFIG_PRPMC750) \
 $(CONFIG_PRPMC800)$(CONFIG_LOPEC)$(CONFIG_PPLUS)
 motorola := $(strip $(motorola))
 pcore := $(CONFIG_PCORE)$(CONFIG_POWERPMC250)

arch/ppc/platforms/Makefile

@@ -30,7 +30,6 @@ obj-$(CONFIG_GEMINI)		+= gemini_pci.o gemini_setup.o gemini_prom.o
 obj-$(CONFIG_LOPEC)		+= lopec.o
 obj-$(CONFIG_KATANA)		+= katana.o
 obj-$(CONFIG_HDPU)		+= hdpu.o
-obj-$(CONFIG_MCPN765)		+= mcpn765.o
 obj-$(CONFIG_MENF1)		+= menf1_setup.o menf1_pci.o
 obj-$(CONFIG_MVME5100)		+= mvme5100.o
 obj-$(CONFIG_PAL4)		+= pal4_setup.o pal4_pci.o

arch/ppc/platforms/mcpn765.h

-/*
- * arch/ppc/platforms/mcpn765.h
- *
- * Definitions for Motorola MCG MCPN765 cPCI Board.
- *
- * Author: Mark A. Greer
- *         mgreer@mvista.com
- *
- * 2001-2004 (c) MontaVista, Software, Inc.  This file is licensed under
- * the terms of the GNU General Public License version 2.  This program
- * is licensed "as is" without any warranty of any kind, whether express
- * or implied.
- */
-
-/*
- * From Processor to PCI:
- *   PCI Mem Space: 0x80000000 - 0xc0000000 -> 0x80000000 - 0xc0000000 (1 GB)
- *   PCI I/O Space: 0xfd800000 - 0xfe000000 -> 0x00000000 - 0x00800000 (8 MB)
- *	Note: Must skip 0xfe000000-0xfe400000 for CONFIG_HIGHMEM/PKMAP area
- *   MPIC in PCI Mem Space: 0xfe800000 - 0xfe830000 (not all used by MPIC)
- *
- * From PCI to Processor:
- *   System Memory: 0x00000000 -> 0x00000000
- */
-
-#ifndef __PPC_PLATFORMS_MCPN765_H
-#define __PPC_PLATFORMS_MCPN765_H
-#include <linux/config.h>
-
-/* PCI Memory space mapping info */
-#define	MCPN765_PCI_MEM_SIZE		0x40000000U
-#define MCPN765_PROC_PCI_MEM_START	0x80000000U
-#define MCPN765_PROC_PCI_MEM_END	(MCPN765_PROC_PCI_MEM_START +	\
-					 MCPN765_PCI_MEM_SIZE - 1)
-#define MCPN765_PCI_MEM_START		0x80000000U
-#define MCPN765_PCI_MEM_END		(MCPN765_PCI_MEM_START +	\
-					 MCPN765_PCI_MEM_SIZE - 1)
-
-/* PCI I/O space mapping info */
-#define	MCPN765_PCI_IO_SIZE		0x00800000U
-#define MCPN765_PROC_PCI_IO_START	0xfd800000U
-#define MCPN765_PROC_PCI_IO_END		(MCPN765_PROC_PCI_IO_START +	\
-					 MCPN765_PCI_IO_SIZE - 1)
-#define MCPN765_PCI_IO_START		0x00000000U
-#define MCPN765_PCI_IO_END		(MCPN765_PCI_IO_START + 	\
-					 MCPN765_PCI_IO_SIZE - 1)
-
-/* System memory mapping info */
-#define MCPN765_PCI_DRAM_OFFSET		0x00000000U
-#define MCPN765_PCI_PHY_MEM_OFFSET	0x00000000U
-
-#define MCPN765_ISA_MEM_BASE		0x00000000U
-#define MCPN765_ISA_IO_BASE		MCPN765_PROC_PCI_IO_START
-
-/* Define base addresses for important sets of registers */
-#define MCPN765_HAWK_MPIC_BASE		0xfe800000U
-#define MCPN765_HAWK_SMC_BASE		0xfef80000U
-#define	MCPN765_HAWK_PPC_REG_BASE	0xfeff0000U
-
-/* Define MCPN765 board register addresses. */
-#define	MCPN765_BOARD_STATUS_REG	0xfef88080U
-#define	MCPN765_BOARD_MODFAIL_REG	0xfef88090U
-#define	MCPN765_BOARD_MODRST_REG	0xfef880a0U
-#define	MCPN765_BOARD_TBEN_REG		0xfef880c0U
-#define	MCPN765_BOARD_GEOGRAPHICAL_REG	0xfef880e8U
-#define	MCPN765_BOARD_EXT_FEATURE_REG	0xfef880f0U
-#define	MCPN765_BOARD_LAST_RESET_REG	0xfef880f8U
-
-/* Defines for UART */
-
-/* Define the UART base addresses */
-#define	MCPN765_SERIAL_1		0xfef88000
-#define	MCPN765_SERIAL_2		0xfef88200
-#define	MCPN765_SERIAL_3		0xfef88400
-#define	MCPN765_SERIAL_4		0xfef88600
-
-#ifdef CONFIG_SERIAL_MANY_PORTS
-#define RS_TABLE_SIZE  64
-#else
-#define RS_TABLE_SIZE  4
-#endif
-
-/* Rate for the 1.8432 Mhz clock for the onboard serial chip */
-#define BASE_BAUD	( 1843200 / 16 )
-#define UART_CLK	1843200
-
-#ifdef CONFIG_SERIAL_DETECT_IRQ
-#define STD_COM_FLAGS (ASYNC_BOOT_AUTOCONF|ASYNC_SKIP_TEST|ASYNC_AUTO_IRQ)
-#else
-#define STD_COM_FLAGS (ASYNC_BOOT_AUTOCONF|ASYNC_SKIP_TEST)
-#endif
-
-/* All UART IRQ's are wire-OR'd to IRQ 17 */
-#define STD_SERIAL_PORT_DFNS \
-        { 0, BASE_BAUD, MCPN765_SERIAL_1, 17, STD_COM_FLAGS, /* ttyS0 */\
-		iomem_base: (u8 *)MCPN765_SERIAL_1,			\
-		iomem_reg_shift: 4,					\
-		io_type: SERIAL_IO_MEM },				\
-        { 0, BASE_BAUD, MCPN765_SERIAL_2, 17, STD_COM_FLAGS, /* ttyS1 */\
-		iomem_base: (u8 *)MCPN765_SERIAL_2,			\
-		iomem_reg_shift: 4,					\
-		io_type: SERIAL_IO_MEM },				\
-        { 0, BASE_BAUD, MCPN765_SERIAL_3, 17, STD_COM_FLAGS, /* ttyS2 */\
-		iomem_base: (u8 *)MCPN765_SERIAL_3,			\
-		iomem_reg_shift: 4,					\
-		io_type: SERIAL_IO_MEM },				\
-        { 0, BASE_BAUD, MCPN765_SERIAL_4, 17, STD_COM_FLAGS, /* ttyS3 */\
-		iomem_base: (u8 *)MCPN765_SERIAL_4,			\
-		iomem_reg_shift: 4,					\
-		io_type: SERIAL_IO_MEM },
-
-#define SERIAL_PORT_DFNS \
-        STD_SERIAL_PORT_DFNS
-
-/* Define the NVRAM/RTC address strobe & data registers */
-#define MCPN765_PHYS_NVRAM_AS0          0xfef880c8U
-#define MCPN765_PHYS_NVRAM_AS1          0xfef880d0U
-#define MCPN765_PHYS_NVRAM_DATA         0xfef880d8U
-
-extern void mcpn765_find_bridges(void);
-
-#endif /* __PPC_PLATFORMS_MCPN765_H */

arch/ppc/syslib/Makefile

@@ -54,8 +54,6 @@ obj-$(CONFIG_LOPEC)		+= i8259.o pci_auto.o todc_time.o
 obj-$(CONFIG_HDPU)		+= pci_auto.o
 obj-$(CONFIG_LUAN)		+= indirect_pci.o pci_auto.o todc_time.o
 obj-$(CONFIG_KATANA)		+= pci_auto.o
-obj-$(CONFIG_MCPN765)		+= todc_time.o indirect_pci.o pci_auto.o \
-					open_pic.o i8259.o hawk_common.o
 obj-$(CONFIG_MENF1)		+= todc_time.o i8259.o mpc10x_common.o \
 					pci_auto.o indirect_pci.o
 obj-$(CONFIG_MV64360)		+= mv64360_pic.o

include/asm-ppc/serial.h

@@ -18,8 +18,6 @@
 #include <platforms/powerpmc250.h>
 #elif defined(CONFIG_LOPEC)
 #include <platforms/lopec.h>
-#elif defined(CONFIG_MCPN765)
-#include <platforms/mcpn765.h>
 #elif defined(CONFIG_MVME5100)
 #include <platforms/mvme5100.h>
 #elif defined(CONFIG_PAL4)