Commit 93ca1610 authored by Bill Hayes's avatar Bill Hayes Committed by David S. Miller

e1000e: alternate MAC address support

Port alternate MAC address support from the sourceforge
e1000 driver to the upstream e1000e driver.
Signed-off-by: default avatarBill Hayes <bill.hayes@hp.com>
Signed-off-by: default avatarAuke Kok <auke-jan.h.kok@intel.com>
Signed-off-by: default avatarJeff Garzik <jeff@garzik.org>
parent 3df5920c
......@@ -752,6 +752,10 @@ static s32 e1000_reset_hw_82571(struct e1000_hw *hw)
ew32(IMC, 0xffffffff);
icr = er32(ICR);
if (hw->mac.type == e1000_82571 &&
hw->dev_spec.e82571.alt_mac_addr_is_present)
e1000e_set_laa_state_82571(hw, true);
return 0;
}
......
......@@ -557,6 +557,7 @@
#define NVM_INIT_3GIO_3 0x001A
#define NVM_INIT_CONTROL3_PORT_A 0x0024
#define NVM_CFG 0x0012
#define NVM_ALT_MAC_ADDR_PTR 0x0037
#define NVM_CHECKSUM_REG 0x003F
#define E1000_NVM_CFG_DONE_PORT_0 0x40000 /* MNG config cycle done */
......
......@@ -816,6 +816,7 @@ struct e1000_bus_info {
struct e1000_dev_spec_82571 {
bool laa_is_present;
bool alt_mac_addr_is_present;
};
struct e1000_shadow_ram {
......
......@@ -2059,9 +2059,44 @@ s32 e1000e_read_mac_addr(struct e1000_hw *hw)
{
s32 ret_val;
u16 offset, nvm_data, i;
u16 mac_addr_offset = 0;
if (hw->mac.type == e1000_82571) {
/* Check for an alternate MAC address. An alternate MAC
* address can be setup by pre-boot software and must be
* treated like a permanent address and must override the
* actual permanent MAC address. */
ret_val = e1000_read_nvm(hw, NVM_ALT_MAC_ADDR_PTR, 1,
&mac_addr_offset);
if (ret_val) {
hw_dbg(hw, "NVM Read Error\n");
return ret_val;
}
if (mac_addr_offset == 0xFFFF)
mac_addr_offset = 0;
if (mac_addr_offset) {
if (hw->bus.func == E1000_FUNC_1)
mac_addr_offset += ETH_ALEN/sizeof(u16);
/* make sure we have a valid mac address here
* before using it */
ret_val = e1000_read_nvm(hw, mac_addr_offset, 1,
&nvm_data);
if (ret_val) {
hw_dbg(hw, "NVM Read Error\n");
return ret_val;
}
if (nvm_data & 0x0001)
mac_addr_offset = 0;
}
if (mac_addr_offset)
hw->dev_spec.e82571.alt_mac_addr_is_present = 1;
}
for (i = 0; i < ETH_ALEN; i += 2) {
offset = i >> 1;
offset = mac_addr_offset + (i >> 1);
ret_val = e1000_read_nvm(hw, offset, 1, &nvm_data);
if (ret_val) {
hw_dbg(hw, "NVM Read Error\n");
......@@ -2072,7 +2107,7 @@ s32 e1000e_read_mac_addr(struct e1000_hw *hw)
}
/* Flip last bit of mac address if we're on second port */
if (hw->bus.func == E1000_FUNC_1)
if (!mac_addr_offset && hw->bus.func == E1000_FUNC_1)
hw->mac.perm_addr[5] ^= 1;
for (i = 0; i < ETH_ALEN; i++)
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment