drm/i915: Fix BXT min_pixclk after state readout

commit 4e5ca60f ("drm/i915: Use ilk_max_pixel_rate() for BXT cdclk calculation")
tried to change BXT to use ilk_max_pixel_rate() to compute the
pipe pixel rate. I failed to notice that there was another place
in the state readout code that needs the same treatment. So let's
change that one too.

Should probably just change things to always compuyte the pipe pixel
rates, instead of just doing on platforms that can change cdclk
dynamically. But for now let's just move BXT fully over to the
side that uses ilk_pipe_pixel_rate().

Cc: Jani Nikula <jani.nikula@intel.com>
Fixes: 4e5ca60f ("drm/i915: Use ilk_max_pixel_rate() for BXT cdclk calculation")
Signed-off-by: Ville Syrjälä <ville.syrjala@linux.intel.com>
Link: http://patchwork.freedesktop.org/patch/msgid/1463172100-24715-2-git-send-email-ville.syrjala@linux.intel.comReviewed-by: Imre Deak <imre.deak@intel.com>

drivers/gpu/drm/i915/intel_display.c

@@ -15128,18 +15128,16 @@ static void intel_modeset_readout_hw_state(struct drm_device *dev)
 		if (crtc_state->base.active) {
 			dev_priv->active_crtcs |= 1 << crtc->pipe;
 
-			if (IS_BROADWELL(dev_priv)) {
+			if (IS_BROXTON(dev_priv) || IS_BROADWELL(dev_priv))
 				pixclk = ilk_pipe_pixel_rate(crtc_state);
-
-				/* pixel rate mustn't exceed 95% of cdclk with IPS on BDW */
-				if (crtc_state->ips_enabled)
-					pixclk = DIV_ROUND_UP(pixclk * 100, 95);
-			} else if (IS_VALLEYVIEW(dev_priv) ||
-				   IS_CHERRYVIEW(dev_priv) ||
-				   IS_BROXTON(dev_priv))
+			else if (IS_VALLEYVIEW(dev_priv) || IS_CHERRYVIEW(dev_priv))
 				pixclk = crtc_state->base.adjusted_mode.crtc_clock;
 			else
 				WARN_ON(dev_priv->display.modeset_calc_cdclk);
+
+			/* pixel rate mustn't exceed 95% of cdclk with IPS on BDW */
+			if (IS_BROADWELL(dev_priv) && crtc_state->ips_enabled)
+				pixclk = DIV_ROUND_UP(pixclk * 100, 95);
 		}
 
 		dev_priv->min_pixclk[crtc->pipe] = pixclk;