Commit 97d26b80 authored by Linus Torvalds's avatar Linus Torvalds

Merge master.kernel.org:/home/rmk/linux-2.6-arm

parents 5131bf5d dcef1f63
......@@ -269,7 +269,7 @@ __pabt_svc:
add r5, sp, #S_PC
ldmia r7, {r2 - r4} @ Get USR pc, cpsr
#if __LINUX_ARM_ARCH__ < 6
#if __LINUX_ARM_ARCH__ < 6 && !defined(CONFIG_NEEDS_SYSCALL_FOR_CMPXCHG)
@ make sure our user space atomic helper is aborted
cmp r2, #VIRT_OFFSET
bichs r3, r3, #PSR_Z_BIT
......@@ -616,11 +616,17 @@ __kuser_helper_start:
__kuser_cmpxchg: @ 0xffff0fc0
#if __LINUX_ARM_ARCH__ < 6
#if defined(CONFIG_NEEDS_SYSCALL_FOR_CMPXCHG)
#ifdef CONFIG_SMP /* sanity check */
#error "CONFIG_SMP on a machine supporting pre-ARMv6 processors?"
#endif
/*
* Poor you. No fast solution possible...
* The kernel itself must perform the operation.
* A special ghost syscall is used for that (see traps.c).
*/
swi #0x9ffff0
mov pc, lr
#elif __LINUX_ARM_ARCH__ < 6
/*
* Theory of operation:
......
......@@ -464,6 +464,55 @@ asmlinkage int arm_syscall(int no, struct pt_regs *regs)
#endif
return 0;
#ifdef CONFIG_NEEDS_SYSCALL_FOR_CMPXCHG
/*
* Atomically store r1 in *r2 if *r2 is equal to r0 for user space.
* Return zero in r0 if *MEM was changed or non-zero if no exchange
* happened. Also set the user C flag accordingly.
* If access permissions have to be fixed up then non-zero is
* returned and the operation has to be re-attempted.
*
* *NOTE*: This is a ghost syscall private to the kernel. Only the
* __kuser_cmpxchg code in entry-armv.S should be aware of its
* existence. Don't ever use this from user code.
*/
case 0xfff0:
{
extern void do_DataAbort(unsigned long addr, unsigned int fsr,
struct pt_regs *regs);
unsigned long val;
unsigned long addr = regs->ARM_r2;
struct mm_struct *mm = current->mm;
pgd_t *pgd; pmd_t *pmd; pte_t *pte;
regs->ARM_cpsr &= ~PSR_C_BIT;
spin_lock(&mm->page_table_lock);
pgd = pgd_offset(mm, addr);
if (!pgd_present(*pgd))
goto bad_access;
pmd = pmd_offset(pgd, addr);
if (!pmd_present(*pmd))
goto bad_access;
pte = pte_offset_map(pmd, addr);
if (!pte_present(*pte) || !pte_write(*pte))
goto bad_access;
val = *(unsigned long *)addr;
val -= regs->ARM_r0;
if (val == 0) {
*(unsigned long *)addr = regs->ARM_r1;
regs->ARM_cpsr |= PSR_C_BIT;
}
spin_unlock(&mm->page_table_lock);
return val;
bad_access:
spin_unlock(&mm->page_table_lock);
/* simulate a read access fault */
do_DataAbort(addr, 15 + (1 << 11), regs);
return -1;
}
#endif
default:
/* Calls 9f00xx..9f07ff are defined to return -ENOSYS
if not implemented, rather than raising SIGILL. This
......
......@@ -87,9 +87,9 @@ ENTRY(__raw_writesw)
subs r2, r2, #2
orr ip, ip, r3, push_hbyte1
strh ip, [r0]
bpl 2b
bpl 1b
3: tst r2, #1
2: movne ip, r3, lsr #8
tst r2, #1
3: movne ip, r3, lsr #8
strneh ip, [r0]
mov pc, lr
......@@ -422,3 +422,11 @@ config HAS_TLS_REG
assume directly accessing that register and always obtain the
expected value only on ARMv7 and above.
config NEEDS_SYSCALL_FOR_CMPXCHG
bool
default y if SMP && (CPU_32v5 || CPU_32v4 || CPU_32v3)
help
SMP on a pre-ARMv6 processor? Well OK then.
Forget about fast user space cmpxchg support.
It is just not possible.
......@@ -1296,6 +1296,7 @@
#define GPIO111_MMCDAT3 111 /* MMC DAT3 (PXA27x) */
#define GPIO111_MMCCS1 111 /* MMC Chip Select 1 (PXA27x) */
#define GPIO112_MMCCMD 112 /* MMC CMD (PXA27x) */
#define GPIO113_I2S_SYSCLK 113 /* I2S System Clock (PXA27x) */
#define GPIO113_AC97_RESET_N 113 /* AC97 NRESET on (PXA27x) */
/* GPIO alternate function mode & direction */
......@@ -1428,6 +1429,7 @@
#define GPIO111_MMCDAT3_MD (111 | GPIO_ALT_FN_1_OUT)
#define GPIO110_MMCCS1_MD (111 | GPIO_ALT_FN_1_OUT)
#define GPIO112_MMCCMD_MD (112 | GPIO_ALT_FN_1_OUT)
#define GPIO113_I2S_SYSCLK_MD (113 | GPIO_ALT_FN_1_OUT)
#define GPIO113_AC97_RESET_N_MD (113 | GPIO_ALT_FN_2_OUT)
#define GPIO117_I2CSCL_MD (117 | GPIO_ALT_FN_1_OUT)
#define GPIO118_I2CSDA_MD (118 | GPIO_ALT_FN_1_IN)
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment