Merge master.kernel.org:/home/rmk/linux-2.6-arm

arch/arm/kernel/entry-armv.S

@@ -269,7 +269,7 @@ __pabt_svc:
 	add	r5, sp, #S_PC
 	ldmia	r7, {r2 - r4}			@ Get USR pc, cpsr
 
-#if __LINUX_ARM_ARCH__ < 6
+#if __LINUX_ARM_ARCH__ < 6 && !defined(CONFIG_NEEDS_SYSCALL_FOR_CMPXCHG)
 	@ make sure our user space atomic helper is aborted
 	cmp	r2, #VIRT_OFFSET
 	bichs	r3, r3, #PSR_Z_BIT
@@ -616,11 +616,17 @@ __kuser_helper_start:
 
 __kuser_cmpxchg:				@ 0xffff0fc0
 
-#if __LINUX_ARM_ARCH__ < 6
+#if defined(CONFIG_NEEDS_SYSCALL_FOR_CMPXCHG)
 
-#ifdef CONFIG_SMP  /* sanity check */
-#error "CONFIG_SMP on a machine supporting pre-ARMv6 processors?"
-#endif
+	/*
+	 * Poor you.  No fast solution possible...
+	 * The kernel itself must perform the operation.
+	 * A special ghost syscall is used for that (see traps.c).
+	 */
+	swi	#0x9ffff0
+	mov	pc, lr
+
+#elif __LINUX_ARM_ARCH__ < 6
 
 	/*
 	 * Theory of operation:

arch/arm/kernel/traps.c

@@ -464,6 +464,55 @@ asmlinkage int arm_syscall(int no, struct pt_regs *regs)
 #endif
 		return 0;
 
+#ifdef CONFIG_NEEDS_SYSCALL_FOR_CMPXCHG
+	/*
+	 * Atomically store r1 in *r2 if *r2 is equal to r0 for user space.
+	 * Return zero in r0 if *MEM was changed or non-zero if no exchange
+	 * happened.  Also set the user C flag accordingly.
+	 * If access permissions have to be fixed up then non-zero is
+	 * returned and the operation has to be re-attempted.
+	 *
+	 * *NOTE*: This is a ghost syscall private to the kernel.  Only the
+	 * __kuser_cmpxchg code in entry-armv.S should be aware of its
+	 * existence.  Don't ever use this from user code.
+	 */
+	case 0xfff0:
+	{
+		extern void do_DataAbort(unsigned long addr, unsigned int fsr,
+					 struct pt_regs *regs);
+		unsigned long val;
+		unsigned long addr = regs->ARM_r2;
+		struct mm_struct *mm = current->mm;
+		pgd_t *pgd; pmd_t *pmd; pte_t *pte;
+
+		regs->ARM_cpsr &= ~PSR_C_BIT;
+		spin_lock(&mm->page_table_lock);
+		pgd = pgd_offset(mm, addr);
+		if (!pgd_present(*pgd))
+			goto bad_access;
+		pmd = pmd_offset(pgd, addr);
+		if (!pmd_present(*pmd))
+			goto bad_access;
+		pte = pte_offset_map(pmd, addr);
+		if (!pte_present(*pte) || !pte_write(*pte))
+			goto bad_access;
+		val = *(unsigned long *)addr;
+		val -= regs->ARM_r0;
+		if (val == 0) {
+			*(unsigned long *)addr = regs->ARM_r1;
+			regs->ARM_cpsr |= PSR_C_BIT;
+		}
+		spin_unlock(&mm->page_table_lock);
+		return val;
+
+		bad_access:
+		spin_unlock(&mm->page_table_lock);
+		/* simulate a read access fault */
+		do_DataAbort(addr, 15 + (1 << 11), regs);
+		return -1;
+	}
+#endif
+
 	default:
 		/* Calls 9f00xx..9f07ff are defined to return -ENOSYS
 		   if not implemented, rather than raising SIGILL.  This

arch/arm/lib/io-writesw-armv4.S

@@ -87,9 +87,9 @@ ENTRY(__raw_writesw)
 		subs	r2, r2, #2
 		orr	ip, ip, r3, push_hbyte1
 		strh	ip, [r0]
-		bpl	2b
+		bpl	1b
 
-3:		tst	r2, #1
-2:		movne	ip, r3, lsr #8
+		tst	r2, #1
+3:		movne	ip, r3, lsr #8
 		strneh	ip, [r0]
 		mov	pc, lr

arch/arm/mm/Kconfig

@@ -422,3 +422,11 @@ config HAS_TLS_REG
 	  assume directly accessing that register and always obtain the
 	  expected value only on ARMv7 and above.
 
+config NEEDS_SYSCALL_FOR_CMPXCHG
+	bool
+	default y if SMP && (CPU_32v5 || CPU_32v4 || CPU_32v3)
+	help
+	  SMP on a pre-ARMv6 processor?  Well OK then.
+	  Forget about fast user space cmpxchg support.
+	  It is just not possible.
+

include/asm-arm/arch-pxa/pxa-regs.h

@@ -1296,6 +1296,7 @@
 #define GPIO111_MMCDAT3		111	/* MMC DAT3 (PXA27x) */
 #define GPIO111_MMCCS1		111	/* MMC Chip Select 1 (PXA27x) */
 #define GPIO112_MMCCMD		112	/* MMC CMD (PXA27x) */
+#define GPIO113_I2S_SYSCLK	113	/* I2S System Clock (PXA27x) */
 #define GPIO113_AC97_RESET_N	113	/* AC97 NRESET on (PXA27x) */
 
 /* GPIO alternate function mode & direction */
@@ -1428,6 +1429,7 @@
 #define GPIO111_MMCDAT3_MD	(111 | GPIO_ALT_FN_1_OUT)
 #define GPIO110_MMCCS1_MD	(111 | GPIO_ALT_FN_1_OUT)
 #define GPIO112_MMCCMD_MD	(112 | GPIO_ALT_FN_1_OUT)
+#define GPIO113_I2S_SYSCLK_MD	(113 | GPIO_ALT_FN_1_OUT)
 #define GPIO113_AC97_RESET_N_MD	(113 | GPIO_ALT_FN_2_OUT)
 #define GPIO117_I2CSCL_MD	(117 | GPIO_ALT_FN_1_OUT)
 #define GPIO118_I2CSDA_MD	(118 | GPIO_ALT_FN_1_IN)