brcmfmac: Clean up interrupt macros

Make it more obvious that this code acually enables interrupts, and
provide nice definitions for the bits in the register.
Signed-off-by: Ian Molton <ian@mnementh.co.uk>
Acked-by: Arend van Spriel <arend.vanspriel@broadcom.com>
Signed-off-by: Arend van Spriel <arend.vanspriel@broadcom.com>
Signed-off-by: Kalle Valo <kvalo@codeaurora.org>

drivers/net/wireless/broadcom/brcm80211/brcmfmac/bcmsdh.c

@@ -149,7 +149,8 @@ int brcmf_sdiod_intr_register(struct brcmf_sdio_dev *sdiodev)
 
 		/* must configure SDIO_CCCR_IENx to enable irq */
 		data = brcmf_sdiod_func0_rb(sdiodev, SDIO_CCCR_IENx, &ret);
-		data |= 1 << SDIO_FUNC_1 | 1 << SDIO_FUNC_2 | 1;
+		data |= SDIO_CCCR_IEN_FUNC1 | SDIO_CCCR_IEN_FUNC2 |
+			SDIO_CCCR_IEN_FUNC0;
 		brcmf_sdiod_func0_wb(sdiodev, SDIO_CCCR_IENx, data, &ret);
 
 		/* redirect, configure and enable io for interrupt signal */

drivers/net/wireless/broadcom/brcm80211/brcmfmac/sdio.h

@@ -24,9 +24,6 @@
 /* Maximum number of I/O funcs */
 #define NUM_SDIO_FUNCS	3
 
-#define SDIO_FUNC_1		1
-#define SDIO_FUNC_2		2
-
 #define SDIOD_FBR_SIZE		0x100
 
 /* io_en */
@@ -52,6 +49,11 @@
 #define SDIO_CCCR_BRCM_CARDCAP_CMD14_EXT	BIT(2)
 #define SDIO_CCCR_BRCM_CARDCAP_CMD_NODEC	BIT(3)
 
+/* Interrupt enable bits for each function */
+#define SDIO_CCCR_IEN_FUNC0			BIT(0)
+#define SDIO_CCCR_IEN_FUNC1			BIT(1)
+#define SDIO_CCCR_IEN_FUNC2			BIT(2)
+
 #define SDIO_CCCR_BRCM_CARDCTRL			0xf1
 #define SDIO_CCCR_BRCM_CARDCTRL_WLANRESET	BIT(1)