Commit 9e975cc2 authored by Matt Carlson's avatar Matt Carlson Committed by David S. Miller

tg3: Fix io failures after chip reset

Commit f2096f94, entitled
"tg3: Add 5720 H2BMC support", needed to add code to preserve some bits
set by firmware.  Unfortunately the new code causes throughput to stop
after a chip reset because it enables state machines before they are
ready.  This patch undoes the problematic code.  The bits will be
restored later in the init sequence.
Signed-off-by: default avatarMatt Carlson <mcarlson@broadcom.com>
Reviewed-by: default avatarMichael Chan <mchan@broadcom.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent 79616895
......@@ -7412,16 +7412,11 @@ static int tg3_chip_reset(struct tg3 *tp)
tw32(TG3PCI_CLOCK_CTRL, tp->pci_clock_ctrl);
}
if (tg3_flag(tp, ENABLE_APE))
tp->mac_mode = MAC_MODE_APE_TX_EN |
MAC_MODE_APE_RX_EN |
MAC_MODE_TDE_ENABLE;
if (tp->phy_flags & TG3_PHYFLG_PHY_SERDES) {
tp->mac_mode |= MAC_MODE_PORT_MODE_TBI;
tp->mac_mode = MAC_MODE_PORT_MODE_TBI;
val = tp->mac_mode;
} else if (tp->phy_flags & TG3_PHYFLG_MII_SERDES) {
tp->mac_mode |= MAC_MODE_PORT_MODE_GMII;
tp->mac_mode = MAC_MODE_PORT_MODE_GMII;
val = tp->mac_mode;
} else
val = 0;
......@@ -8559,12 +8554,11 @@ static int tg3_reset_hw(struct tg3 *tp, int reset_phy)
udelay(10);
}
if (tg3_flag(tp, ENABLE_APE))
tp->mac_mode = MAC_MODE_APE_TX_EN | MAC_MODE_APE_RX_EN;
else
tp->mac_mode = 0;
tp->mac_mode |= MAC_MODE_TXSTAT_ENABLE | MAC_MODE_RXSTAT_ENABLE |
MAC_MODE_TDE_ENABLE | MAC_MODE_RDE_ENABLE | MAC_MODE_FHDE_ENABLE;
MAC_MODE_TDE_ENABLE | MAC_MODE_RDE_ENABLE |
MAC_MODE_FHDE_ENABLE;
if (tg3_flag(tp, ENABLE_APE))
tp->mac_mode |= MAC_MODE_APE_TX_EN | MAC_MODE_APE_RX_EN;
if (!tg3_flag(tp, 5705_PLUS) &&
!(tp->phy_flags & TG3_PHYFLG_PHY_SERDES) &&
GET_ASIC_REV(tp->pci_chip_rev_id) != ASIC_REV_5700)
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment