ath10k: use hw_params.num_peers for num_tids in TLV init

As TARGET_TLV_NUM_TIDS is calculated like this:

	#define TARGET_TLV_NUM_TIDS ((TARGET_TLV_NUM_PEERS) * 2)

... it is better to use the per device hw_params.num_peers value in
the TLV init message (if set), rather than using a hard coded value.

This makes the value used in the TLV init message match the hw_param
value.
Signed-off-by: Erik Stromdahl <erik.stromdahl@gmail.com>
Signed-off-by: Kalle Valo <kvalo@codeaurora.org>

drivers/net/wireless/ath/ath10k/wmi-tlv.c

@@ -1582,7 +1582,10 @@ static struct sk_buff *ath10k_wmi_tlv_op_gen_init(struct ath10k *ar)
 	}
 
 	cfg->num_peer_keys = __cpu_to_le32(2);
-	cfg->num_tids = __cpu_to_le32(TARGET_TLV_NUM_TIDS);
+	if (ar->hw_params.num_peers)
+		cfg->num_tids = __cpu_to_le32(ar->hw_params.num_peers * 2);
+	else
+		cfg->num_tids = __cpu_to_le32(TARGET_TLV_NUM_TIDS);
 	cfg->tx_chain_mask = __cpu_to_le32(0x7);
 	cfg->rx_chain_mask = __cpu_to_le32(0x7);
 	cfg->rx_timeout_pri[0] = __cpu_to_le32(0x64);