Commit a1433ac4 authored by Stephen Hemminger's avatar Stephen Hemminger Committed by Jeff Garzik

[PATCH] sky2: fix jumbo packet support

The truncate threshold calculation to prevent receiver from getting stuck
was incorrect, and it didn't take into account the upper limit on bits
in the register so the jumbo packet support was broken.
Signed-off-by: default avatarStephen Hemminger <shemminger@osdl.org>
Signed-off-by: default avatarJeff Garzik <jeff@garzik.org>
parent 387e2b04
...@@ -979,6 +979,7 @@ static int sky2_rx_start(struct sky2_port *sky2) ...@@ -979,6 +979,7 @@ static int sky2_rx_start(struct sky2_port *sky2)
struct sky2_hw *hw = sky2->hw; struct sky2_hw *hw = sky2->hw;
unsigned rxq = rxqaddr[sky2->port]; unsigned rxq = rxqaddr[sky2->port];
int i; int i;
unsigned thresh;
sky2->rx_put = sky2->rx_next = 0; sky2->rx_put = sky2->rx_next = 0;
sky2_qset(hw, rxq); sky2_qset(hw, rxq);
...@@ -1003,9 +1004,21 @@ static int sky2_rx_start(struct sky2_port *sky2) ...@@ -1003,9 +1004,21 @@ static int sky2_rx_start(struct sky2_port *sky2)
sky2_rx_add(sky2, re->mapaddr); sky2_rx_add(sky2, re->mapaddr);
} }
/* Truncate oversize frames */
sky2_write16(hw, SK_REG(sky2->port, RX_GMF_TR_THR), sky2->rx_bufsize - 8); /*
sky2_write32(hw, SK_REG(sky2->port, RX_GMF_CTRL_T), RX_TRUNC_ON); * The receiver hangs if it receives frames larger than the
* packet buffer. As a workaround, truncate oversize frames, but
* the register is limited to 9 bits, so if you do frames > 2052
* you better get the MTU right!
*/
thresh = (sky2->rx_bufsize - 8) / sizeof(u32);
if (thresh > 0x1ff)
sky2_write32(hw, SK_REG(sky2->port, RX_GMF_CTRL_T), RX_TRUNC_OFF);
else {
sky2_write16(hw, SK_REG(sky2->port, RX_GMF_TR_THR), thresh);
sky2_write32(hw, SK_REG(sky2->port, RX_GMF_CTRL_T), RX_TRUNC_ON);
}
/* Tell chip about available buffers */ /* Tell chip about available buffers */
sky2_write16(hw, Y2_QADDR(rxq, PREF_UNIT_PUT_IDX), sky2->rx_put); sky2_write16(hw, Y2_QADDR(rxq, PREF_UNIT_PUT_IDX), sky2->rx_put);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment