Commit a44f59d6 authored by Larry Finger's avatar Larry Finger Committed by Kalle Valo

rtlwifi: rtl8192ee: Remove all instances of DBG_EMERG

This is a step toward eliminating the RT_TRACE macros. Those calls that
have DBG_EMERG as the level are always logged, and they represent error
conditions, thus they are replaced with pr_err().
Signed-off-by: default avatarLarry Finger <Larry.Finger@lwfinger.net>
Cc: Ping-Ke Shih <pkshih@realtek.com>
Signed-off-by: default avatarKalle Valo <kvalo@codeaurora.org>
parent a67005bc
......@@ -122,10 +122,8 @@ static void _rtl92ee_write_fw(struct ieee80211_hw *hw,
pagenums = size / FW_8192C_PAGE_SIZE;
remainsize = size % FW_8192C_PAGE_SIZE;
if (pagenums > 8) {
RT_TRACE(rtlpriv, COMP_ERR, DBG_EMERG,
"Page numbers should not greater then 8\n");
}
if (pagenums > 8)
pr_err("Page numbers should not greater then 8\n");
for (page = 0; page < pagenums; page++) {
offset = page * FW_8192C_PAGE_SIZE;
......@@ -155,14 +153,13 @@ static int _rtl92ee_fw_free_to_go(struct ieee80211_hw *hw)
(!(value32 & FWDL_CHKSUM_RPT)));
if (counter >= FW_8192C_POLLING_TIMEOUT_COUNT) {
RT_TRACE(rtlpriv, COMP_ERR, DBG_EMERG,
"chksum report faill ! REG_MCUFWDL:0x%08x .\n",
value32);
pr_err("chksum report fail! REG_MCUFWDL:0x%08x\n",
value32);
goto exit;
}
RT_TRACE(rtlpriv, COMP_FW, DBG_TRACE,
"Checksum report OK ! REG_MCUFWDL:0x%08x .\n", value32);
"Checksum report OK! REG_MCUFWDL:0x%08x\n", value32);
value32 = rtl_read_dword(rtlpriv, REG_MCUFWDL);
value32 |= MCUFWDL_RDY;
......@@ -186,9 +183,8 @@ static int _rtl92ee_fw_free_to_go(struct ieee80211_hw *hw)
} while (counter++ < FW_8192C_POLLING_TIMEOUT_COUNT);
RT_TRACE(rtlpriv, COMP_ERR, DBG_EMERG,
"Polling FW ready fail!! REG_MCUFWDL:0x%08x. count = %d\n",
value32, counter);
pr_err("Polling FW ready fail!! REG_MCUFWDL:0x%08x. count = %d\n",
value32, counter);
exit:
return err;
......@@ -241,8 +237,7 @@ int rtl92ee_download_fw(struct ieee80211_hw *hw, bool buse_wake_on_wlan_fw)
err = _rtl92ee_fw_free_to_go(hw);
if (err) {
RT_TRACE(rtlpriv, COMP_ERR, DBG_EMERG,
"Firmware is not ready to run!\n");
pr_err("Firmware is not ready to run!\n");
} else {
RT_TRACE(rtlpriv, COMP_FW, DBG_LOUD ,
"Firmware is ready to run!\n");
......
......@@ -1320,7 +1320,7 @@ int rtl92ee_hw_init(struct ieee80211_hw *hw)
rtl_write_byte(rtlpriv, 0x65, 1);
}
if (!rtstatus) {
RT_TRACE(rtlpriv, COMP_ERR, DBG_EMERG, "Init MAC failed\n");
pr_err("Init MAC failed\n");
err = 1;
return err;
}
......@@ -1485,8 +1485,7 @@ static int _rtl92ee_set_media_status(struct ieee80211_hw *hw,
"Set Network type to AP!\n");
break;
default:
RT_TRACE(rtlpriv, COMP_ERR, DBG_EMERG,
"Network type %d not support!\n", type);
pr_err("Network type %d not support!\n", type);
return 1;
}
......@@ -2206,7 +2205,7 @@ void rtl92ee_read_eeprom_info(struct ieee80211_hw *hw)
rtlefuse->autoload_failflag = false;
_rtl92ee_read_adapter_info(hw);
} else {
RT_TRACE(rtlpriv, COMP_ERR, DBG_EMERG, "Autoload ERR!!\n");
pr_err("Autoload ERR!!\n");
}
_rtl92ee_hal_customized_behavior(hw);
......@@ -2484,9 +2483,7 @@ void rtl92ee_set_key(struct ieee80211_hw *hw, u32 key_index,
entry_id = rtl_cam_get_free_entry(hw,
p_macaddr);
if (entry_id >= TOTAL_CAM_ENTRY) {
RT_TRACE(rtlpriv, COMP_SEC,
DBG_EMERG,
"Can not find free hw security cam entry\n");
pr_err("Can not find free hw security cam entry\n");
return;
}
} else {
......
......@@ -170,7 +170,7 @@ static u32 _rtl92ee_phy_rf_serial_read(struct ieee80211_hw *hw,
offset &= 0xff;
newoffset = offset;
if (RT_CANNOT_IO(hw)) {
RT_TRACE(rtlpriv, COMP_ERR, DBG_EMERG, "return all one\n");
pr_err("return all one\n");
return 0xFFFFFFFF;
}
tmplong = rtl_get_bbreg(hw, RFPGA0_XA_HSSIPARAMETER2, MASKDWORD);
......@@ -214,7 +214,7 @@ static void _rtl92ee_phy_rf_serial_write(struct ieee80211_hw *hw,
struct bb_reg_def *pphyreg = &rtlphy->phyreg_def[rfpath];
if (RT_CANNOT_IO(hw)) {
RT_TRACE(rtlpriv, COMP_ERR, DBG_EMERG, "stop\n");
pr_err("stop\n");
return;
}
offset &= 0xff;
......@@ -650,7 +650,7 @@ static bool _rtl92ee_phy_bb8192ee_config_parafile(struct ieee80211_hw *hw)
rtstatus = phy_config_bb_with_hdr_file(hw, BASEBAND_CONFIG_PHY_REG);
if (!rtstatus) {
RT_TRACE(rtlpriv, COMP_ERR, DBG_EMERG, "Write BB Reg Fail!!\n");
pr_err("Write BB Reg Fail!!\n");
return false;
}
......@@ -662,12 +662,12 @@ static bool _rtl92ee_phy_bb8192ee_config_parafile(struct ieee80211_hw *hw)
}
_rtl92ee_phy_txpower_by_rate_configuration(hw);
if (!rtstatus) {
RT_TRACE(rtlpriv, COMP_ERR, DBG_EMERG, "BB_PG Reg Fail!!\n");
pr_err("BB_PG Reg Fail!!\n");
return false;
}
rtstatus = phy_config_bb_with_hdr_file(hw, BASEBAND_CONFIG_AGC_TAB);
if (!rtstatus) {
RT_TRACE(rtlpriv, COMP_ERR, DBG_EMERG, "AGC Table Fail\n");
pr_err("AGC Table Fail\n");
return false;
}
rtlphy->cck_high_power = (bool)(rtl_get_bbreg(hw,
......@@ -1675,8 +1675,7 @@ void rtl92ee_phy_scan_operation_backup(struct ieee80211_hw *hw, u8 operation)
(u8 *)&iotype);
break;
default:
RT_TRACE(rtlpriv, COMP_ERR, DBG_EMERG,
"Unknown Scan Backup operation.\n");
pr_err("Unknown Scan Backup operation.\n");
break;
}
}
......@@ -1717,8 +1716,8 @@ void rtl92ee_phy_set_bw_mode_callback(struct ieee80211_hw *hw)
rtl_write_byte(rtlpriv, REG_RRSR + 2, reg_prsr_rsc);
break;
default:
RT_TRACE(rtlpriv, COMP_ERR, DBG_EMERG,
"unknown bandwidth: %#X\n", rtlphy->current_chan_bw);
pr_err("unknown bandwidth: %#X\n",
rtlphy->current_chan_bw);
break;
}
......@@ -1742,8 +1741,8 @@ void rtl92ee_phy_set_bw_mode_callback(struct ieee80211_hw *hw)
HAL_PRIME_CHNL_OFFSET_LOWER) ? 2 : 1);
break;
default:
RT_TRACE(rtlpriv, COMP_ERR, DBG_EMERG,
"unknown bandwidth: %#X\n", rtlphy->current_chan_bw);
pr_err("unknown bandwidth: %#X\n",
rtlphy->current_chan_bw);
break;
}
rtl92ee_phy_rf6052_set_bandwidth(hw, rtlphy->current_chan_bw);
......@@ -1884,8 +1883,8 @@ static bool _rtl92ee_phy_sw_chnl_step_by_step(struct ieee80211_hw *hw,
currentcmd = &postcommoncmd[*step];
break;
default:
RT_TRACE(rtlpriv, COMP_ERR, DBG_EMERG,
"Invalid 'stage' = %d, Check it!\n" , *stage);
pr_err("Invalid 'stage' = %d, Check it!\n",
*stage);
return true;
}
......
......@@ -55,8 +55,7 @@ void rtl92ee_phy_rf6052_set_bandwidth(struct ieee80211_hw *hw, u8 bandwidth)
rtlphy->rfreg_chnlval[0]);
break;
default:
RT_TRACE(rtlpriv, COMP_ERR, DBG_EMERG,
"unknown bandwidth: %#X\n", bandwidth);
pr_err("unknown bandwidth: %#X\n", bandwidth);
break;
}
}
......
......@@ -165,8 +165,7 @@ int rtl92ee_init_sw_vars(struct ieee80211_hw *hw)
/* for firmware buf */
rtlpriv->rtlhal.pfirmware = vzalloc(0x8000);
if (!rtlpriv->rtlhal.pfirmware) {
RT_TRACE(rtlpriv, COMP_ERR, DBG_EMERG,
"Can't alloc buffer for fw\n");
pr_err("Can't alloc buffer for fw\n");
return 1;
}
......@@ -179,8 +178,7 @@ int rtl92ee_init_sw_vars(struct ieee80211_hw *hw)
rtlpriv->io.dev, GFP_KERNEL, hw,
rtl_fw_cb);
if (err) {
RT_TRACE(rtlpriv, COMP_ERR, DBG_EMERG,
"Failed to request firmware!\n");
pr_err("Failed to request firmware!\n");
return 1;
}
......@@ -260,7 +258,7 @@ static struct rtl_mod_params rtl92ee_mod_params = {
.swctrl_lps = false,
.fwctrl_lps = true,
.msi_support = true,
.debug = DBG_EMERG,
.debug = 0,
};
static const struct rtl_hal_cfg rtl92ee_hal_cfg = {
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment