ARM: dts: imx23-evk: add auart device

Add auart device for imx23-evk board.
Signed-off-by: Shawn Guo <shawn.guo@linaro.org>

arch/arm/boot/dts/imx23-evk.dts

@@ -51,6 +51,12 @@ hog_pins_a: hog-gpios@0 {
 		};
 
 		apbx@80040000 {
+			auart0: serial@8006c000 {
+				pinctrl-names = "default";
+				pinctrl-0 = <&auart0_pins_a>;
+				status = "okay";
+			};
+
 			duart: serial@80070000 {
 				pinctrl-names = "default";
 				pinctrl-0 = <&duart_pins_a>;

arch/arm/boot/dts/imx23.dtsi

@@ -18,6 +18,8 @@ aliases {
 		gpio0 = &gpio0;
 		gpio1 = &gpio1;
 		gpio2 = &gpio2;
+		serial0 = &auart0;
+		serial1 = &auart1;
 	};
 
 	cpus {
@@ -123,6 +125,19 @@ duart_pins_a: duart@0 {
 					fsl,pull-up = <0>;
 				};
 
+				auart0_pins_a: auart0@0 {
+					reg = <0>;
+					fsl,pinmux-ids = <
+						0x01c0 /* MX23_PAD_AUART1_RX__AUART1_RX */
+						0x01d0 /* MX23_PAD_AUART1_TX__AUART1_TX */
+						0x01a0 /* MX23_PAD_AUART1_CTS__AUART1_CTS */
+						0x01b0 /* MX23_PAD_AUART1_RTS__AUART1_RTS */
+					>;
+					fsl,drive-strength = <0>;
+					fsl,voltage = <1>;
+					fsl,pull-up = <0>;
+				};
+
 				mmc0_4bit_pins_a: mmc0-4bit@0 {
 					reg = <0>;
 					fsl,pinmux-ids = <
@@ -289,12 +304,16 @@ timrot@80068000 {
 			};
 
 			auart0: serial@8006c000 {
+				compatible = "fsl,imx23-auart";
 				reg = <0x8006c000 0x2000>;
+				interrupts = <24 25 23>;
 				status = "disabled";
 			};
 
 			auart1: serial@8006e000 {
+				compatible = "fsl,imx23-auart";
 				reg = <0x8006e000 0x2000>;
+				interrupts = <59 60 58>;
 				status = "disabled";
 			};