drm/i915: Move the PIPEMISC write the correct place

I fumbled the PIPEMISC write into the wrong place. It only gets
called for fastsets, but since value needs to be updated based on
the set of active planes it needs to be done for all plane updates.
Move it to the correct spot.

The symptoms include SDR planes never showing up if a previous
modeset/fastset left the pipe in HDR mode. This was immediately
obvious when running the kms_plane pixel format tests. Unfortunately
the test didn't realize it was scanning out pure black all the time
and declared success anyway.

Cc: Uma Shankar <uma.shankar@intel.com>
Cc: Shashank Sharma <shashank.sharma@intel.com>
Fixes: 09b25812 ("drm/i915: Enable pipe HDR mode on ICL if only HDR planes are used")
Signed-off-by: Ville Syrjälä <ville.syrjala@linux.intel.com>
Link: https://patchwork.freedesktop.org/patch/msgid/20190502200607.14504-1-ville.syrjala@linux.intel.comReviewed-by: Uma Shankar <uma.shankar@intel.com>

drivers/gpu/drm/i915/intel_display.c

@@ -4101,9 +4101,6 @@ static void intel_update_pipe_config(const struct intel_crtc_state *old_crtc_sta
 			ironlake_pfit_disable(old_crtc_state);
 	}
 
-	if (INTEL_GEN(dev_priv) >= 9 || IS_BROADWELL(dev_priv))
-		bdw_set_pipemisc(new_crtc_state);
-
 	if (INTEL_GEN(dev_priv) >= 11)
 		icl_set_pipe_chicken(crtc);
 }
@@ -14173,6 +14170,9 @@ static void intel_begin_crtc_commit(struct intel_atomic_state *state,
 	else if (INTEL_GEN(dev_priv) >= 9)
 		skl_detach_scalers(new_crtc_state);
 
+	if (INTEL_GEN(dev_priv) >= 9 || IS_BROADWELL(dev_priv))
+		bdw_set_pipemisc(new_crtc_state);
+
 out:
 	if (dev_priv->display.atomic_update_watermarks)
 		dev_priv->display.atomic_update_watermarks(state,