Commit a968b5e9 authored by Vinod Koul's avatar Vinod Koul Committed by David S. Miller

net: dsa: qca8k: Enable delay for RGMII_ID mode

RGMII_ID specifies that we should have internal delay, so resurrect the
delay addition routine but under the RGMII_ID mode.

Fixes: 40269aa9f40a ("net: dsa: qca8k: disable delay for RGMII mode")
Tested-by: default avatarMichal Vokáč <michal.vokac@ysoft.com>
Signed-off-by: default avatarVinod Koul <vkoul@kernel.org>
Reviewed-by: default avatarAndrew Lunn <andrew@lunn.ch>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent 57701171
......@@ -443,6 +443,18 @@ qca8k_set_pad_ctrl(struct qca8k_priv *priv, int port, int mode)
val = QCA8K_PORT_PAD_RGMII_EN;
qca8k_write(priv, reg, val);
break;
case PHY_INTERFACE_MODE_RGMII_ID:
/* RGMII_ID needs internal delay. This is enabled through
* PORT5_PAD_CTRL for all ports, rather than individual port
* registers
*/
qca8k_write(priv, reg,
QCA8K_PORT_PAD_RGMII_EN |
QCA8K_PORT_PAD_RGMII_TX_DELAY(QCA8K_MAX_DELAY) |
QCA8K_PORT_PAD_RGMII_RX_DELAY(QCA8K_MAX_DELAY));
qca8k_write(priv, QCA8K_REG_PORT5_PAD_CTRL,
QCA8K_PORT_PAD_RGMII_RX_DELAY_EN);
break;
case PHY_INTERFACE_MODE_SGMII:
qca8k_write(priv, reg, QCA8K_PORT_PAD_SGMII_EN);
break;
......
......@@ -40,6 +40,7 @@
((0x8 + (x & 0x3)) << 22)
#define QCA8K_PORT_PAD_RGMII_RX_DELAY(x) \
((0x10 + (x & 0x3)) << 20)
#define QCA8K_MAX_DELAY 3
#define QCA8K_PORT_PAD_RGMII_RX_DELAY_EN BIT(24)
#define QCA8K_PORT_PAD_SGMII_EN BIT(7)
#define QCA8K_REG_MODULE_EN 0x030
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment