Commit abceddb4 authored by Ben Cahill's avatar Ben Cahill Committed by David S. Miller

iwlwifi: Document 4965 rate_n_flags bits

Document 4965 rate_n_flags bits
Signed-off-by: default avatarBen Cahill <ben.m.cahill@intel.com>
Signed-off-by: default avatarZhu Yi <yi.zhu@intel.com>
Signed-off-by: default avatarJohn W. Linville <linville@tuxdriver.com>
parent bc47279f
......@@ -141,7 +141,8 @@ enum {
/******************************************************************************
* (0)
* Header
* Commonly used structures and definitions:
* Command header, rate_n_flags
*
*****************************************************************************/
......@@ -167,6 +168,89 @@ struct iwl4965_cmd_header {
u8 data[0];
} __attribute__ ((packed));
/**
* 4965 rate_n_flags bit fields
*
* rate_n_flags format is used in following 4965 commands:
* REPLY_4965_RX (response only)
* REPLY_TX (both command and response)
* REPLY_TX_LINK_QUALITY_CMD
*
* High-throughput (HT) rate format for bits 7:0 (bit 8 must be "1"):
* 2-0: 0) 6 Mbps
* 1) 12 Mbps
* 2) 18 Mbps
* 3) 24 Mbps
* 4) 36 Mbps
* 5) 48 Mbps
* 6) 54 Mbps
* 7) 60 Mbps
*
* 3: 0) Single stream (SISO)
* 1) Dual stream (MIMO)
*
* 5: Value of 0x20 in bits 7:0 indicates 6 Mbps FAT duplicate data
*
* Legacy OFDM rate format for bits 7:0 (bit 8 must be "0", bit 9 "0"):
* 3-0: 0xD) 6 Mbps
* 0xF) 9 Mbps
* 0x5) 12 Mbps
* 0x7) 18 Mbps
* 0x9) 24 Mbps
* 0xB) 36 Mbps
* 0x1) 48 Mbps
* 0x3) 54 Mbps
*
* Legacy CCK rate format for bits 7:0 (bit 8 must be "0", bit 9 "1"):
* 3-0: 10) 1 Mbps
* 20) 2 Mbps
* 55) 5.5 Mbps
* 110) 11 Mbps
*/
#define RATE_MCS_CODE_MSK 0x7
#define RATE_MCS_MIMO_POS 3
#define RATE_MCS_MIMO_MSK 0x8
#define RATE_MCS_HT_DUP_POS 5
#define RATE_MCS_HT_DUP_MSK 0x20
/* (1) HT format, (0) legacy format in bits 7:0 */
#define RATE_MCS_FLAGS_POS 8
#define RATE_MCS_HT_POS 8
#define RATE_MCS_HT_MSK 0x100
/* (1) CCK, (0) OFDM. HT (bit 8) must be "0" for this bit to be valid */
#define RATE_MCS_CCK_POS 9
#define RATE_MCS_CCK_MSK 0x200
/* (1) Use Green Field preamble */
#define RATE_MCS_GF_POS 10
#define RATE_MCS_GF_MSK 0x400
/* (1) Use 40Mhz FAT channel width, (0) use 20 MHz legacy channel width */
#define RATE_MCS_FAT_POS 11
#define RATE_MCS_FAT_MSK 0x800
/* (1) Duplicate data on both 20MHz channels. FAT (bit 11) must be set. */
#define RATE_MCS_DUP_POS 12
#define RATE_MCS_DUP_MSK 0x1000
/* (1) Short guard interval (0.4 usec), (0) normal GI (0.8 usec) */
#define RATE_MCS_SGI_POS 13
#define RATE_MCS_SGI_MSK 0x2000
/**
* rate_n_flags Tx antenna masks (4965 has 2 transmitters):
* bit14:15 01 B inactive, A active
* 10 B active, A inactive
* 11 Both active
*/
#define RATE_MCS_ANT_A_POS 14
#define RATE_MCS_ANT_B_POS 15
#define RATE_MCS_ANT_A_MSK 0x4000
#define RATE_MCS_ANT_B_MSK 0x8000
#define RATE_MCS_ANT_AB_MSK 0xc000
/******************************************************************************
* (0a)
* Alive and Error Commands & Responses:
......@@ -452,18 +536,6 @@ struct iwl4965_qosparam_cmd {
#define STA_MODIFY_DELBA_TID_MSK 0x10
#define BUILD_RAxTID(sta_id, tid) (((sta_id) << 4) + (tid))
/*
* Antenna masks:
* bit14:15 01 B inactive, A active
* 10 B active, A inactive
* 11 Both active
*/
#define RATE_MCS_ANT_A_POS 14
#define RATE_MCS_ANT_B_POS 15
#define RATE_MCS_ANT_A_MSK 0x4000
#define RATE_MCS_ANT_B_MSK 0x8000
#define RATE_MCS_ANT_AB_MSK 0xc000
struct iwl4965_keyinfo {
__le16 key_flags;
u8 tkip_rx_tsc_byte2; /* TSC[2] for key mix ph1 detection */
......
......@@ -883,6 +883,11 @@ struct iwl4965_traffic_load {
};
#ifdef CONFIG_IWL4965_HT_AGG
/**
* struct iwl4965_agg_control
* @requested_ba: bit map of tids requesting aggregation/block-ack
* @granted_ba: bit map of tids granted aggregation/block-ack
*/
struct iwl4965_agg_control {
unsigned long next_retry;
u32 wait_for_agg_status;
......@@ -1054,29 +1059,8 @@ struct iwl4965_chain_noise_data {
u8 radio_write;
};
/* IWL4965 */
#define RATE_MCS_CODE_MSK 0x7
#define RATE_MCS_MIMO_POS 3
#define RATE_MCS_MIMO_MSK 0x8
#define RATE_MCS_HT_DUP_POS 5
#define RATE_MCS_HT_DUP_MSK 0x20
#define RATE_MCS_FLAGS_POS 8
#define RATE_MCS_HT_POS 8
#define RATE_MCS_HT_MSK 0x100
#define RATE_MCS_CCK_POS 9
#define RATE_MCS_CCK_MSK 0x200
#define RATE_MCS_GF_POS 10
#define RATE_MCS_GF_MSK 0x400
#define RATE_MCS_FAT_POS 11
#define RATE_MCS_FAT_MSK 0x800
#define RATE_MCS_DUP_POS 12
#define RATE_MCS_DUP_MSK 0x1000
#define RATE_MCS_SGI_POS 13
#define RATE_MCS_SGI_MSK 0x2000
#define EEPROM_SEM_TIMEOUT 10
#define EEPROM_SEM_RETRY_LIMIT 1000
#define EEPROM_SEM_TIMEOUT 10 /* milliseconds */
#define EEPROM_SEM_RETRY_LIMIT 1000 /* number of attempts (not time) */
#ifdef CONFIG_IWL4965_SPECTRUM_MEASUREMENT
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment