Commit ae0219cb authored by Andrew Lunn's avatar Andrew Lunn Committed by David S. Miller

net: phy: Use phy name when requesting the interrupt

Using the fixed name "phy_interrupt" is not very informative in
/proc/interrupts when there are a lot of phys, e.g. a device with an
Ethernet switch. So when requesting the interrupt, use the name of the
phy.
Signed-off-by: default avatarAndrew Lunn <andrew@lunn.ch>
Acked-by: default avatarFlorian Fainelli <f.fainelli@gmail.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent 664fcf12
...@@ -736,8 +736,7 @@ int phy_start_interrupts(struct phy_device *phydev) ...@@ -736,8 +736,7 @@ int phy_start_interrupts(struct phy_device *phydev)
atomic_set(&phydev->irq_disable, 0); atomic_set(&phydev->irq_disable, 0);
if (request_threaded_irq(phydev->irq, NULL, phy_interrupt, if (request_threaded_irq(phydev->irq, NULL, phy_interrupt,
IRQF_ONESHOT | IRQF_SHARED, IRQF_ONESHOT | IRQF_SHARED,
"phy_interrupt", phydev_name(phydev), phydev) < 0) {
phydev) < 0) {
pr_warn("%s: Can't get IRQ %d (PHY)\n", pr_warn("%s: Can't get IRQ %d (PHY)\n",
phydev->mdio.bus->name, phydev->irq); phydev->mdio.bus->name, phydev->irq);
phydev->irq = PHY_POLL; phydev->irq = PHY_POLL;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment