ath10k: override CE5 config for QCA9377

Similarly to QCA6174, QCA9377 requires the CE5 configuration to be
available for other feature. Use the ath10k_pci_override_ce_config()
for it as well.

This is required for TF2.0 firmware. Previous FW revisions were
working fine without this patch.

Fixes: a70587b3 ("ath10k: configure copy engine 5 for HTT messages")
Signed-off-by: Bartosz Markowski <bartosz.markowski@tieto.com>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>

drivers/net/wireless/ath/ath10k/pci.c

@@ -3132,7 +3132,7 @@ int ath10k_pci_setup_resource(struct ath10k *ar)
 	setup_timer(&ar_pci->rx_post_retry, ath10k_pci_rx_replenish_retry,
 		    (unsigned long)ar);
 
-	if (QCA_REV_6174(ar))
+	if (QCA_REV_6174(ar) || QCA_REV_9377(ar))
 		ath10k_pci_override_ce_config(ar);
 
 	ret = ath10k_pci_alloc_pipes(ar);