Commit b0942f78 authored by Krzysztof Hałasa's avatar Krzysztof Hałasa

WAN: HD64572 already handles TX underruns with DMAC.

Signed-off-by: default avatarKrzysztof Hałasa <khc@pm.waw.pl>
parent 09fd65aa
......@@ -232,19 +232,12 @@ static inline void sca_msci_intr(port_t *port)
{
u16 msci = get_msci(port);
card_t* card = port_to_card(port);
u8 stat = sca_in(msci + ST1, card); /* read MSCI ST1 status */
/* Reset MSCI TX underrun and CDCD status bit */
sca_out(stat & (ST1_UDRN | ST1_CDCD), msci + ST1, card);
if (stat & ST1_UDRN) {
/* TX Underrun error detected */
port_to_dev(port)->stats.tx_errors++;
port_to_dev(port)->stats.tx_fifo_errors++;
}
if (stat & ST1_CDCD)
if (sca_in(msci + ST1, card) & ST1_CDCD) {
/* Reset MSCI CDCD status bit */
sca_out(ST1_CDCD, msci + ST1, card);
sca_set_carrier(port);
}
}
......@@ -351,11 +344,17 @@ static inline void sca_tx_done(port_t *port)
while (1) {
pkt_desc __iomem *desc = desc_address(port, port->txlast, 1);
u8 stat = readb(&desc->stat);
if (!(readb(&desc->stat) & ST_TX_OWNRSHP))
if (!(stat & ST_TX_OWNRSHP))
break; /* not yet transmitted */
dev->stats.tx_packets++;
dev->stats.tx_bytes += readw(&desc->len);
if (stat & ST_TX_UNDRRUN) {
dev->stats.tx_errors++;
dev->stats.tx_fifo_errors++;
} else {
dev->stats.tx_packets++;
dev->stats.tx_bytes += readw(&desc->len);
}
writeb(0, &desc->stat); /* Free descriptor */
port->txlast = next_desc(port, port->txlast, 1);
}
......@@ -503,12 +502,11 @@ static void sca_open(struct net_device *dev)
sca_out(0x3F, msci + TNR1, card); /* +1=TX DMA deactivation condition*/
/* We're using the following interrupts:
- TXINT (DMAC completed all transmissions, underrun or DCD change)
- TXINT (DMAC completed all transmissions and DCD changes)
- all DMA interrupts
*/
/* MSCI TXINT and RXINTA interrupt enable */
sca_outl(IE0_TXINT | IE0_RXINTA | IE0_UDRN | IE0_CDCD, msci + IE0,
card);
sca_outl(IE0_TXINT | IE0_RXINTA | IE0_CDCD, msci + IE0, card);
sca_out(port->tmc, msci + TMCR, card);
sca_out(port->tmc, msci + TMCT, card);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment