ath10k: fill in wmi 10.4 command handlers for addba/delba debug commands

WMI 10.4 uses the same command interface as QCA988X for addba/delba
debug wmi commands. Fill wmi_10_4_ops table with the functions used
for QCA988X for these commands.

With this change, the following debugfs entries can be used to
configure the aggregation mode and to send addba request,
addba response and delba respectively in manual aggregation mode
for QCA99X0 chip.

/sys/kernel/debug/ieee80211/phyX/netdev:wlanX/stations/XX:XX:XX:XX:XX:XX/aggr_mode
/sys/kernel/debug/ieee80211/phyX/netdev:wlanX/stations/XX:XX:XX:XX:XX:XX/addba
/sys/kernel/debug/ieee80211/phyX/netdev:wlanX/stations/XX:XX:XX:XX:XX:XX/addba_resp
/sys/kernel/debug/ieee80211/phyX/netdev:wlanX/stations/XX:XX:XX:XX:XX:XX/delba
Signed-off-by: Vasanthakumar Thiagarajan <vthiagar@qti.qualcomm.com>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>

drivers/net/wireless/ath/ath10k/wmi.c

@@ -6597,6 +6597,10 @@ static const struct wmi_ops wmi_10_4_ops = {
 	.gen_pktlog_enable = ath10k_wmi_op_gen_pktlog_enable,
 	.gen_pktlog_disable = ath10k_wmi_op_gen_pktlog_disable,
 	.gen_pdev_set_quiet_mode = ath10k_wmi_op_gen_pdev_set_quiet_mode,
+	.gen_addba_clear_resp = ath10k_wmi_op_gen_addba_clear_resp,
+	.gen_addba_send = ath10k_wmi_op_gen_addba_send,
+	.gen_addba_set_resp = ath10k_wmi_op_gen_addba_set_resp,
+	.gen_delba_send = ath10k_wmi_op_gen_delba_send,
 
 	/* shared with 10.2 */
 	.gen_peer_assoc = ath10k_wmi_10_2_op_gen_peer_assoc,