staging: comedi: ni_daq_700: change the 'attach' printk's to dev_printk's

Use the dev_printk() routines to output the kernel messages in the
attach routine.

The main 'attach' message had a level of KERN_ERR, I believe it should
have been KERN_INFO. Also, move that message to the end of the attach
so it only gets displayed if the attach is successful.
Signed-off-by: H Hartley Sweeten <hsweeten@visionengravers.com>
Cc: Ian Abbott <abbotti@mev.co.uk>
Cc: Frank Mori Hess <fmhess@users.sourceforge.net>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/staging/comedi/drivers/ni_daq_700.c

@@ -113,11 +113,8 @@ static int dio700_attach(struct comedi_device *dev, struct comedi_devconfig *it)
 		return -EIO;
 	iobase = link->resource[0]->start;
 
-	printk(KERN_ERR "comedi%d: ni_daq_700: %s, io 0x%lx\n", dev->minor,
-	       thisboard->name, iobase);
-
 	if (iobase == 0) {
-		printk(KERN_ERR "io base address is zero!\n");
+		dev_err(dev->class_dev, "io base address is zero!\n");
 		return -EINVAL;
 	}
 
@@ -142,6 +139,11 @@ static int dio700_attach(struct comedi_device *dev, struct comedi_devconfig *it)
 	s->state	= 0;
 	s->io_bits	= 0x00ff;
 
+	dev_info(dev->class_dev, "%s: %s, io 0x%lx\n",
+		dev->driver->driver_name,
+		dev->board_name,
+		dev->iobase);
+
 	return 0;
 };