usb: musb: set TXMAXP and AUTOSET for full speed bulk in device mode

The TXMAXP register is not set correctly for full speed bulk case
when the can_bulk_split() is used. Without this PIO transfers will
not take place correctly

The "mult" factor needs to be updated correctly for the
can_bulk_split() case

The AUTOSET bit in the TXCSR is not being set if the "mult"
factor is greater than 0 for the High Bandwidth ISO case.
But the "mult" factor is also greater than 0 in case of Full speed
bulk transfers with the packet splitting in TXMAXP register

Without the AUTOSET the DMA transfers will not progress in mode1

[ balbi@ti.com : add braces to both branches ]
Signed-off-by: supriya karanth <supriya.karanth@stericsson.com>
Signed-off-by: Praveena NADAHALLY <praveen.nadahally@stericsson.com>
Acked-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Felipe Balbi <balbi@ti.com>

drivers/usb/musb/musb_gadget.c

@@ -408,7 +408,19 @@ static void txstate(struct musb *musb, struct musb_request *req)
 					csr |= (MUSB_TXCSR_DMAENAB
 							| MUSB_TXCSR_DMAMODE
 							| MUSB_TXCSR_MODE);
-					if (!musb_ep->hb_mult)
+					/*
+					 * Enable Autoset according to table
+					 * below
+					 * bulk_split hb_mult	Autoset_Enable
+					 *	0	0	Yes(Normal)
+					 *	0	>0	No(High BW ISO)
+					 *	1	0	Yes(HS bulk)
+					 *	1	>0	Yes(FS bulk)
+					 */
+					if (!musb_ep->hb_mult ||
+						(musb_ep->hb_mult &&
+						 can_bulk_split(musb,
+						    musb_ep->type)))
 						csr |= MUSB_TXCSR_AUTOSET;
 				}
 				csr &= ~MUSB_TXCSR_P_UNDERRUN;
@@ -1110,11 +1122,15 @@ static int musb_gadget_enable(struct usb_ep *ep,
 		/* Set TXMAXP with the FIFO size of the endpoint
 		 * to disable double buffering mode.
 		 */
-		if (musb->double_buffer_not_ok)
+		if (musb->double_buffer_not_ok) {
 			musb_writew(regs, MUSB_TXMAXP, hw_ep->max_packet_sz_tx);
-		else
+		} else {
+			if (can_bulk_split(musb, musb_ep->type))
+				musb_ep->hb_mult = (hw_ep->max_packet_sz_tx /
+							musb_ep->packet_sz) - 1;
 			musb_writew(regs, MUSB_TXMAXP, musb_ep->packet_sz
 					| (musb_ep->hb_mult << 11));
+		}
 
 		csr = MUSB_TXCSR_MODE | MUSB_TXCSR_CLRDATATOG;
 		if (musb_readw(regs, MUSB_TXCSR)