Commit bc23d6b7 authored by Kalesh Purayil's avatar Kalesh Purayil Committed by David S. Miller

be2net: remove redundant D0 power state set

pci_enable_device() call sets device power state to D0; there is no need
doing it again.
Signed-off-by: default avatarKalesh AP <kalesh.purayil@avagotech.com>
Signed-off-by: default avatarSathya Perla <sathya.perla@avagotech.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent ff9ed19d
...@@ -5807,7 +5807,6 @@ static int be_pci_resume(struct pci_dev *pdev) ...@@ -5807,7 +5807,6 @@ static int be_pci_resume(struct pci_dev *pdev)
if (status) if (status)
return status; return status;
pci_set_power_state(pdev, PCI_D0);
pci_restore_state(pdev); pci_restore_state(pdev);
status = be_resume(adapter); status = be_resume(adapter);
...@@ -5887,7 +5886,6 @@ static pci_ers_result_t be_eeh_reset(struct pci_dev *pdev) ...@@ -5887,7 +5886,6 @@ static pci_ers_result_t be_eeh_reset(struct pci_dev *pdev)
return PCI_ERS_RESULT_DISCONNECT; return PCI_ERS_RESULT_DISCONNECT;
pci_set_master(pdev); pci_set_master(pdev);
pci_set_power_state(pdev, PCI_D0);
pci_restore_state(pdev); pci_restore_state(pdev);
/* Check if card is ok and fw is ready */ /* Check if card is ok and fw is ready */
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment