MIPS: MTX-1: Make au1000_eth probe all PHY addresses

When au1000_eth probes the MII bus for PHY address, if we do not set
au1000_eth platform data's phy_search_highest_address, the MII probing
logic will exit early and will assume a valid PHY is found at address 0.
For MTX-1, the PHY is at address 31, and without this patch, the link
detection/speed/duplex would not work correctly.

CC: stable@kernel.org
Signed-off-by: Florian Fainelli <florian@openwrt.org>
To: linux-mips@linux-mips.org
Patchwork: https://patchwork.linux-mips.org/patch/2111/Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

arch/mips/alchemy/mtx-1/platform.c

@@ -28,6 +28,8 @@
 #include <linux/mtd/physmap.h>
 #include <mtd/mtd-abi.h>
 
+#include <asm/mach-au1x00/au1xxx_eth.h>
+
 static struct gpio_keys_button mtx1_gpio_button[] = {
 	{
 		.gpio = 207,
@@ -140,10 +142,17 @@ static struct __initdata platform_device * mtx1_devs[] = {
 	&mtx1_mtd,
 };
 
+static struct au1000_eth_platform_data mtx1_au1000_eth0_pdata = {
+	.phy_search_highest_addr	= 1,
+	.phy1_search_mac0 		= 1,
+};
+
 static int __init mtx1_register_devices(void)
 {
 	int rc;
 
+	au1xxx_override_eth_cfg(0, &mtx1_au1000_eth0_pdata);
+
 	rc = gpio_request(mtx1_gpio_button[0].gpio,
 					mtx1_gpio_button[0].desc);
 	if (rc < 0) {