x86/realmode: Add SEV-ES specific trampoline entry point

The code at the trampoline entry point is executed in real-mode. In
real-mode, #VC exceptions can't be handled so anything that might cause
such an exception must be avoided.

In the standard trampoline entry code this is the WBINVD instruction and
the call to verify_cpu(), which are both not needed anyway when running
as an SEV-ES guest.
Signed-off-by: Joerg Roedel <jroedel@suse.de>
Signed-off-by: Borislav Petkov <bp@suse.de>
Link: https://lkml.kernel.org/r/20200907131613.12703-66-joro@8bytes.org

arch/x86/include/asm/realmode.h

@@ -21,6 +21,9 @@ struct real_mode_header {
 	/* SMP trampoline */
 	u32	trampoline_start;
 	u32	trampoline_header;
+#ifdef CONFIG_AMD_MEM_ENCRYPT
+	u32	sev_es_trampoline_start;
+#endif
 #ifdef CONFIG_X86_64
 	u32	trampoline_pgd;
 #endif

arch/x86/realmode/rm/header.S

@@ -20,6 +20,9 @@ SYM_DATA_START(real_mode_header)
 	/* SMP trampoline */
 	.long	pa_trampoline_start
 	.long	pa_trampoline_header
+#ifdef CONFIG_AMD_MEM_ENCRYPT
+	.long	pa_sev_es_trampoline_start
+#endif
 #ifdef CONFIG_X86_64
 	.long	pa_trampoline_pgd;
 #endif

arch/x86/realmode/rm/trampoline_64.S

@@ -56,6 +56,7 @@ SYM_CODE_START(trampoline_start)
 	testl   %eax, %eax		# Check for return code
 	jnz	no_longmode
 
+.Lswitch_to_protected:
 	/*
 	 * GDT tables in non default location kernel can be beyond 16MB and
 	 * lgdt will not be able to load the address as in real mode default
@@ -80,6 +81,25 @@ no_longmode:
 	jmp no_longmode
 SYM_CODE_END(trampoline_start)
 
+#ifdef CONFIG_AMD_MEM_ENCRYPT
+/* SEV-ES supports non-zero IP for entry points - no alignment needed */
+SYM_CODE_START(sev_es_trampoline_start)
+	cli			# We should be safe anyway
+
+	LJMPW_RM(1f)
+1:
+	mov	%cs, %ax	# Code and data in the same place
+	mov	%ax, %ds
+	mov	%ax, %es
+	mov	%ax, %ss
+
+	# Setup stack
+	movl	$rm_stack_end, %esp
+
+	jmp	.Lswitch_to_protected
+SYM_CODE_END(sev_es_trampoline_start)
+#endif	/* CONFIG_AMD_MEM_ENCRYPT */
+
 #include "../kernel/verify_cpu.S"
 
 	.section ".text32","ax"