ARM: dts: imx6qdl-colibri: use pull-down on wake-up pin

The wake-up pin is pulled low with 100kOhm on the carrier board.
The current configuration of 100kOhm pull-up caused lots of
interrupts, especially during boot up. Make sure the pin is at a
reasonable level at startup by pulling it low on SoC side too.
Signed-off-by: Stefan Agner <stefan@agner.ch>
Signed-off-by: Shawn Guo <shawnguo@kernel.org>

arch/arm/boot/dts/imx6qdl-colibri.dtsi

@@ -480,8 +480,7 @@ MX6QDL_PAD_EIM_D26__GPIO3_IO26		0x1b0b0
 
 	pinctrl_gpio_keys: gpiokeys {
 		fsl,pins = <
-			/* Power button */
-			MX6QDL_PAD_EIM_A16__GPIO2_IO22		0x1b0b0
+			MX6QDL_PAD_EIM_A16__GPIO2_IO22		0x130b0
 		>;
 	};