Commit c44379e2 authored by Amitkumar Karwar's avatar Amitkumar Karwar Committed by John W. Linville

mwifiex: use VHT MCS mask in set bitrate mask handler

As V15 firmware supports VHT rate configuration, we can use this
information received in set bitrate mask handler.
Signed-off-by: default avatarAmitkumar Karwar <akarwar@marvell.com>
Signed-off-by: default avatarBing Zhao <bzhao@marvell.com>
Signed-off-by: default avatarJohn W. Linville <linville@tuxdriver.com>
parent a0b7315a
......@@ -1158,9 +1158,10 @@ static int mwifiex_cfg80211_set_bitrate_mask(struct wiphy *wiphy,
struct mwifiex_private *priv = mwifiex_netdev_get_priv(dev);
u16 bitmap_rates[MAX_BITMAP_RATES_SIZE];
enum ieee80211_band band;
struct mwifiex_adapter *adapter = priv->adapter;
if (!priv->media_connected) {
dev_err(priv->adapter->dev,
dev_err(adapter->dev,
"Can not set Tx data rate in disconnected state\n");
return -EINVAL;
}
......@@ -1181,9 +1182,16 @@ static int mwifiex_cfg80211_set_bitrate_mask(struct wiphy *wiphy,
/* Fill HT MCS rates */
bitmap_rates[2] = mask->control[band].ht_mcs[0];
if (priv->adapter->hw_dev_mcs_support == HT_STREAM_2X2)
if (adapter->hw_dev_mcs_support == HT_STREAM_2X2)
bitmap_rates[2] |= mask->control[band].ht_mcs[1] << 8;
/* Fill VHT MCS rates */
if (adapter->fw_api_ver == MWIFIEX_FW_V15) {
bitmap_rates[10] = mask->control[band].vht_mcs[0];
if (adapter->hw_dev_mcs_support == HT_STREAM_2X2)
bitmap_rates[11] = mask->control[band].vht_mcs[1];
}
return mwifiex_send_cmd(priv, HostCmd_CMD_TX_RATE_CFG,
HostCmd_ACT_GEN_SET, 0, bitmap_rates, true);
}
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment