[SCSI] qla2xxx: Issue correct MBC_INITIALIZE_FIRMWARE command.

There is a case where 54xx HBA loads MID firmware as it use 24xx
firmware. In this case, the driver should issue
MBC_MID_INITIALIZE FIRMWARE even though the HBA doesn't support
NPIV.  This patch make changes in the driver so that could behave
accordingly.
Signed-off-by: Seokmann Ju <seokmann.ju@qlogic.com>
Signed-off-by: James Bottomley <James.Bottomley@HansenPartnership.com>

drivers/scsi/qla2xxx/qla_init.c

@@ -1193,7 +1193,9 @@ qla2x00_init_rings(scsi_qla_host_t *ha)
 
 	DEBUG(printk("scsi(%ld): Issue init firmware.\n", ha->host_no));
 
-	mid_init_cb->count = cpu_to_le16(ha->max_npiv_vports);
+	if (ha->flags.npiv_supported)
+		mid_init_cb->count = cpu_to_le16(ha->max_npiv_vports);
+
 	mid_init_cb->options = __constant_cpu_to_le16(BIT_1);
 
 	rval = qla2x00_init_firmware(ha, ha->init_cb_size);

drivers/scsi/qla2xxx/qla_mbx.c

@@ -980,7 +980,7 @@ qla2x00_init_firmware(scsi_qla_host_t *ha, uint16_t size)
 	DEBUG11(printk("qla2x00_init_firmware(%ld): entered.\n",
 	    ha->host_no));
 
-	if (ha->flags.npiv_supported)
+	if (ha->fw_attributes & BIT_2)
 		mcp->mb[0] = MBC_MID_INITIALIZE_FIRMWARE;
 	else
 		mcp->mb[0] = MBC_INITIALIZE_FIRMWARE;