tg3: Clear RECOVERY_PENDING with reset_task_cancel

If an error happens in the tx completion thread, tg3_reset_task will be
scheduled and TX_RECOVERY_PENDING will be set.  The TX_RECOVERY_PENDING
flag causes tg3_poll[_msix] to return early before doing much of its
work.  Tg3_reset_task() gets canceled when the configuration of the
device is changing, which always results in a chip reset.  When this
happens, the TX_RECOVERY_PENDING flag may be left set, which would
unnecessarily hinder tg3_poll from doing work.  This patch fixes the
problem.
Signed-off-by: Matt Carlson <mcarlson@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/broadcom/tg3.c

@@ -6163,6 +6163,7 @@ static inline void tg3_reset_task_cancel(struct tg3 *tp)
 {
 	cancel_work_sync(&tp->reset_task);
 	tg3_flag_clear(tp, RESET_TASK_PENDING);
+	tg3_flag_clear(tp, TX_RECOVERY_PENDING);
 }
 
 static int tg3_poll_msix(struct napi_struct *napi, int budget)
@@ -15937,7 +15938,6 @@ static pci_ers_result_t tg3_io_error_detected(struct pci_dev *pdev,
 
 	/* Want to make sure that the reset task doesn't run */
 	tg3_reset_task_cancel(tp);
-	tg3_flag_clear(tp, TX_RECOVERY_PENDING);
 
 	netif_device_detach(netdev);