scsi: dpt_i2o: use dma_set_mask

The driver currently uses pci_set_dma_mask despite otherwise using the
generic DMA API.  Also move the dma_get_required_mask check before actually
setting the dma mask, so that we don't end up with inconsistent settings in
corner cases.
Signed-off-by: Christoph Hellwig <hch@lst.de>
Signed-off-by: Martin K. Petersen <martin.petersen@oracle.com>

drivers/scsi/dpt_i2o.c

@@ -934,15 +934,15 @@ static int adpt_install_hba(struct scsi_host_template* sht, struct pci_dev* pDev
 	 *	See if we should enable dma64 mode.
 	 */
 	if (sizeof(dma_addr_t) > 4 &&
-	    pci_set_dma_mask(pDev, DMA_BIT_MASK(64)) == 0) {
-		if (dma_get_required_mask(&pDev->dev) > DMA_BIT_MASK(32))
-			dma64 = 1;
-	}
-	if (!dma64 && pci_set_dma_mask(pDev, DMA_BIT_MASK(32)) != 0)
+	    dma_get_required_mask(&pDev->dev) > DMA_BIT_MASK(32) &&
+	    dma_set_mask(&pDev->dev, DMA_BIT_MASK(64)) == 0)
+		dma64 = 1;
+
+	if (!dma64 && dma_set_mask(&pDev->dev, DMA_BIT_MASK(32)) != 0)
 		return -EINVAL;
 
 	/* adapter only supports message blocks below 4GB */
-	pci_set_consistent_dma_mask(pDev, DMA_BIT_MASK(32));
+	dma_set_coherent_mask(&pDev->dev, DMA_BIT_MASK(32));
 
 	base_addr0_phys = pci_resource_start(pDev,0);
 	hba_map0_area_size = pci_resource_len(pDev,0);