spi: qup: Convert ot let spi core handle checking transfer speed

Set master->max_speed_hz then spi core will handle checking transfer speed.
So we can remove the same checking in this driver.

Also remove checking spi->chip_select in spi_qup_setup(), the checking is done
by spi core.
Signed-off-by: Axel Lin <axel.lin@ingics.com>
Acked-by: Ivan T. Ivanov <iivanov@mm-sol.com>
Signed-off-by: Mark Brown <broonie@linaro.org>

drivers/spi/spi-qup.c

@@ -134,7 +134,6 @@ struct spi_qup {
 	struct clk		*cclk;	/* core clock */
 	struct clk		*iclk;	/* interface clock */
 	int			irq;
-	u32			max_speed_hz;
 	spinlock_t		lock;
 
 	int			in_fifo_sz;
@@ -517,18 +516,6 @@ static int spi_qup_setup(struct spi_device *spi)
 	struct spi_qup *controller = spi_master_get_devdata(spi->master);
 	struct spi_qup_device *chip = spi_get_ctldata(spi);
 
-	if (spi->chip_select >= spi->master->num_chipselect) {
-		dev_err(controller->dev, "invalid chip_select %d\n",
-			spi->chip_select);
-		return -EINVAL;
-	}
-
-	if (spi->max_speed_hz > controller->max_speed_hz) {
-		dev_err(controller->dev, "invalid max_speed_hz %d\n",
-			spi->max_speed_hz);
-		return -EINVAL;
-	}
-
 	if (!chip) {
 		/* First setup */
 		chip = kzalloc(sizeof(*chip), GFP_KERNEL);
@@ -629,6 +616,7 @@ static int spi_qup_probe(struct platform_device *pdev)
 	master->mode_bits = SPI_CPOL | SPI_CPHA | SPI_CS_HIGH | SPI_LOOP;
 	master->num_chipselect = SPI_NUM_CHIPSELECTS;
 	master->bits_per_word_mask = SPI_BPW_RANGE_MASK(4, 32);
+	master->max_speed_hz = max_freq;
 	master->setup = spi_qup_setup;
 	master->cleanup = spi_qup_cleanup;
 	master->set_cs = spi_qup_set_cs;
@@ -645,7 +633,6 @@ static int spi_qup_probe(struct platform_device *pdev)
 	controller->iclk = iclk;
 	controller->cclk = cclk;
 	controller->irq = irq;
-	controller->max_speed_hz = max_freq;
 
 	spin_lock_init(&controller->lock);
 	init_completion(&controller->done);