i40e: remove debugfs tx_timeout support

The tx_timeout command from debugfs was originally intended to support
early silicon validation efforts. It is no longer needed. Thus remove it to
avoid misuse of triggering tx_timeout through debugfs.
Signed-off-by: Lihong Yang <lihong.yang@intel.com>
Tested-by: Andrew Bowers <andrewx.bowers@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>

drivers/net/ethernet/intel/i40e/i40e_debugfs.c

@@ -1642,30 +1642,7 @@ static ssize_t i40e_dbg_netdev_ops_write(struct file *filp,
 		count = buf_tmp - i40e_dbg_netdev_ops_buf + 1;
 	}
 
-	if (strncmp(i40e_dbg_netdev_ops_buf, "tx_timeout", 10) == 0) {
-		cnt = sscanf(&i40e_dbg_netdev_ops_buf[11], "%i", &vsi_seid);
-		if (cnt != 1) {
-			dev_info(&pf->pdev->dev, "tx_timeout <vsi_seid>\n");
-			goto netdev_ops_write_done;
-		}
-		vsi = i40e_dbg_find_vsi(pf, vsi_seid);
-		if (!vsi) {
-			dev_info(&pf->pdev->dev,
-				 "tx_timeout: VSI %d not found\n", vsi_seid);
-		} else if (!vsi->netdev) {
-			dev_info(&pf->pdev->dev, "tx_timeout: no netdev for VSI %d\n",
-				 vsi_seid);
-		} else if (test_bit(__I40E_VSI_DOWN, vsi->state)) {
-			dev_info(&pf->pdev->dev, "tx_timeout: VSI %d not UP\n",
-				 vsi_seid);
-		} else if (rtnl_trylock()) {
-			vsi->netdev->netdev_ops->ndo_tx_timeout(vsi->netdev);
-			rtnl_unlock();
-			dev_info(&pf->pdev->dev, "tx_timeout called\n");
-		} else {
-			dev_info(&pf->pdev->dev, "Could not acquire RTNL - please try again\n");
-		}
-	} else if (strncmp(i40e_dbg_netdev_ops_buf, "change_mtu", 10) == 0) {
+	if (strncmp(i40e_dbg_netdev_ops_buf, "change_mtu", 10) == 0) {
 		int mtu;
 
 		cnt = sscanf(&i40e_dbg_netdev_ops_buf[11], "%i %i",
@@ -1733,7 +1710,6 @@ static ssize_t i40e_dbg_netdev_ops_write(struct file *filp,
 		dev_info(&pf->pdev->dev, "unknown command '%s'\n",
 			 i40e_dbg_netdev_ops_buf);
 		dev_info(&pf->pdev->dev, "available commands\n");
-		dev_info(&pf->pdev->dev, "  tx_timeout <vsi_seid>\n");
 		dev_info(&pf->pdev->dev, "  change_mtu <vsi_seid> <mtu>\n");
 		dev_info(&pf->pdev->dev, "  set_rx_mode <vsi_seid>\n");
 		dev_info(&pf->pdev->dev, "  napi <vsi_seid>\n");