Commit d6f35c71 authored by Antti Palosaari's avatar Antti Palosaari Committed by Mauro Carvalho Chehab

[media] cypress_firmware: use Kernel dev_foo() logging

Signed-off-by: default avatarAntti Palosaari <crope@iki.fi>
Signed-off-by: default avatarMauro Carvalho Chehab <mchehab@redhat.com>
parent 3d8866db
......@@ -30,6 +30,9 @@ static const struct usb_cypress_controller cypress[] = {
static int usb_cypress_writemem(struct usb_device *udev, u16 addr, u8 *data,
u8 len)
{
dvb_usb_dbg_usb_control_msg(udev,
0xa0, USB_TYPE_VENDOR, addr, 0x00, data, len);
return usb_control_msg(udev, usb_sndctrlpipe(udev, 0),
0xa0, USB_TYPE_VENDOR, addr, 0x00, data, len, 5000);
}
......@@ -45,24 +48,24 @@ int usbv2_cypress_load_firmware(struct usb_device *udev,
reset = 1;
ret = usb_cypress_writemem(udev, cypress[type].cs_reg, &reset, 1);
if (ret != 1)
pr_err("%s: could not stop the USB controller CPU",
dev_err(&udev->dev,
"%s: could not stop the USB controller CPU\n",
KBUILD_MODNAME);
while ((ret = dvb_usbv2_get_hexline(fw, &hx, &pos)) > 0) {
pr_debug("%s: writing to address %04x (buffer: %02x %02x)\n",
__func__, hx.addr, hx.len, hx.chk);
ret = usb_cypress_writemem(udev, hx.addr, hx.data, hx.len);
if (ret != hx.len) {
pr_err("%s: error while transferring firmware " \
"(transferred size=%d, block size=%d)",
dev_err(&udev->dev, "%s: error while transferring " \
"firmware (transferred size=%d, " \
"block size=%d)\n",
KBUILD_MODNAME, ret, hx.len);
ret = -EINVAL;
break;
}
}
if (ret < 0) {
pr_err("%s: firmware download failed at %d with %d",
dev_err(&udev->dev,
"%s: firmware download failed at %d with %d\n",
KBUILD_MODNAME, pos, ret);
return ret;
}
......@@ -72,8 +75,8 @@ int usbv2_cypress_load_firmware(struct usb_device *udev,
reset = 0;
if (ret || usb_cypress_writemem(
udev, cypress[type].cs_reg, &reset, 1) != 1) {
pr_err("%s: could not restart the USB controller CPU",
KBUILD_MODNAME);
dev_err(&udev->dev, "%s: could not restart the USB " \
"controller CPU\n", KBUILD_MODNAME);
ret = -EINVAL;
}
} else
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment