Commit da533bb0 authored by Sakari Ailus's avatar Sakari Ailus Committed by Mauro Carvalho Chehab

media: smiapp: Don't update sensor configuration during power-on init

The sensor configuration since it was previously powered off was not
changed, so no need to update the PLL configuration etc. What is necessary
though is to re-apply the configuration to the sensor's registers.
Signed-off-by: default avatarSakari Ailus <sakari.ailus@linux.intel.com>
Signed-off-by: default avatarMauro Carvalho Chehab <mchehab+samsung@kernel.org>
parent f8c4352c
...@@ -1267,10 +1267,6 @@ static int smiapp_power_on(struct device *dev) ...@@ -1267,10 +1267,6 @@ static int smiapp_power_on(struct device *dev)
rval = __v4l2_ctrl_handler_setup(&sensor->src->ctrl_handler); rval = __v4l2_ctrl_handler_setup(&sensor->src->ctrl_handler);
if (rval) if (rval)
goto out_cci_addr_fail; goto out_cci_addr_fail;
rval = smiapp_update_mode(sensor);
if (rval < 0)
goto out_cci_addr_fail;
} }
mutex_unlock(&sensor->mutex); mutex_unlock(&sensor->mutex);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment