pinctrl: Add NVIDIA Tegra XUSB pad controller support

The XUSB pad controller found on NVIDIA Tegra SoCs provides several pads
that lanes can be assigned to in order to support a variety of interface
options: USB 2.0, USB 3.0, PCIe and SATA.

In addition to the pin controller used to assign lanes to pads two PHYs
are exposed to allow the bricks for PCIe and SATA to be powered up and
down by PCIe and SATA drivers.
Tested-by: Mikko Perttunen <mperttunen@nvidia.com>
Acked-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Thierry Reding <treding@nvidia.com>

drivers/pinctrl/Kconfig

@@ -328,6 +328,12 @@ config PINCTRL_TEGRA124
 	bool
 	select PINCTRL_TEGRA
 
+config PINCTRL_TEGRA_XUSB
+	def_bool y if ARCH_TEGRA
+	select GENERIC_PHY
+	select PINCONF
+	select PINMUX
+
 config PINCTRL_TZ1090
 	bool "Toumaz Xenif TZ1090 pin control driver"
 	depends on SOC_TZ1090

drivers/pinctrl/Makefile

@@ -55,6 +55,7 @@ obj-$(CONFIG_PINCTRL_TEGRA20)	+= pinctrl-tegra20.o
 obj-$(CONFIG_PINCTRL_TEGRA30)	+= pinctrl-tegra30.o
 obj-$(CONFIG_PINCTRL_TEGRA114)	+= pinctrl-tegra114.o
 obj-$(CONFIG_PINCTRL_TEGRA124)	+= pinctrl-tegra124.o
+obj-$(CONFIG_PINCTRL_TEGRA_XUSB)	+= pinctrl-tegra-xusb.o
 obj-$(CONFIG_PINCTRL_TZ1090)	+= pinctrl-tz1090.o
 obj-$(CONFIG_PINCTRL_TZ1090_PDC)	+= pinctrl-tz1090-pdc.o
 obj-$(CONFIG_PINCTRL_U300)	+= pinctrl-u300.o