ARM: LPAE: use phys_addr_t for initrd location

This patch fixes the initrd setup code to use phys_addr_t instead of assuming
32-bit addressing.  Without this we cannot boot on systems where initrd is
located above the 4G physical address limit.
Signed-off-by: Vitaly Andrianov <vitalya@ti.com>
Signed-off-by: Cyril Chemparathy <cyril@ti.com>
Acked-by: Nicolas Pitre <nico@linaro.org>
Acked-by: Catalin Marinas <catalin.marinas@arm.com>
Tested-by: Santosh Shilimkar <santosh.shilimkar@ti.com>
Tested-by: Subash Patel <subash.rp@samsung.com>
Signed-off-by: Will Deacon <will.deacon@arm.com>

arch/arm/mm/init.c

@@ -36,12 +36,13 @@
 
 #include "mm.h"
 
-static unsigned long phys_initrd_start __initdata = 0;
+static phys_addr_t phys_initrd_start __initdata = 0;
 static unsigned long phys_initrd_size __initdata = 0;
 
 static int __init early_initrd(char *p)
 {
-	unsigned long start, size;
+	phys_addr_t start;
+	unsigned long size;
 	char *endp;
 
 	start = memparse(p, &endp);
@@ -350,14 +351,14 @@ void __init arm_memblock_init(struct meminfo *mi, struct machine_desc *mdesc)
 #ifdef CONFIG_BLK_DEV_INITRD
 	if (phys_initrd_size &&
 	    !memblock_is_region_memory(phys_initrd_start, phys_initrd_size)) {
-		pr_err("INITRD: 0x%08lx+0x%08lx is not a memory region - disabling initrd\n",
-		       phys_initrd_start, phys_initrd_size);
+		pr_err("INITRD: 0x%08llx+0x%08lx is not a memory region - disabling initrd\n",
+		       (u64)phys_initrd_start, phys_initrd_size);
 		phys_initrd_start = phys_initrd_size = 0;
 	}
 	if (phys_initrd_size &&
 	    memblock_is_region_reserved(phys_initrd_start, phys_initrd_size)) {
-		pr_err("INITRD: 0x%08lx+0x%08lx overlaps in-use memory region - disabling initrd\n",
-		       phys_initrd_start, phys_initrd_size);
+		pr_err("INITRD: 0x%08llx+0x%08lx overlaps in-use memory region - disabling initrd\n",
+		       (u64)phys_initrd_start, phys_initrd_size);
 		phys_initrd_start = phys_initrd_size = 0;
 	}
 	if (phys_initrd_size) {