Merge branch 'upstream' of git://ftp.linux-mips.org/pub/scm/upstream-linus

* 'upstream' of git://ftp.linux-mips.org/pub/scm/upstream-linus:
  [MIPS] Fix CONFIG_BOOT_RAW.
  [MIPS] Assume R4000/R4400 newer than 3.0 don't have the mfc0 count bug
  [MIPS] Fix IP32 breakage
  [MIPS] Alchemy: Fix use of __init code bug exposed by modpost warning
  [MIPS] Move inclusing of kernel/time/Kconfig menu to appropriate place

arch/mips/Kconfig

@@ -992,8 +992,6 @@ config BOOT_ELF64
 
 menu "CPU selection"
 
-source "kernel/time/Kconfig"
-
 choice
 	prompt "CPU type"
 	default CPU_R4X00
@@ -1768,6 +1766,8 @@ config NR_CPUS
 	  performance should round up your number of processors to the next
 	  power of two.
 
+source "kernel/time/Kconfig"
+
 #
 # Timer Interrupt Frequency Configuration
 #

arch/mips/au1000/common/pci.c

 /*
  * BRIEF MODULE DESCRIPTION
- *	Alchemy/AMD Au1x00 pci support.
+ *	Alchemy/AMD Au1x00 PCI support.
  *
- * Copyright 2001,2002,2003 MontaVista Software Inc.
+ * Copyright 2001-2003, 2007 MontaVista Software Inc.
  * Author: MontaVista Software, Inc.
  *         	ppopov@mvista.com or source@mvista.com
  *
@@ -66,6 +66,8 @@ static unsigned long virt_io_addr;
 
 static int __init au1x_pci_setup(void)
 {
+	extern void au1x_pci_cfg_init(void);
+
 #if defined(CONFIG_SOC_AU1500) || defined(CONFIG_SOC_AU1550)
 	virt_io_addr = (unsigned long)ioremap(Au1500_PCI_IO_START,
 			Au1500_PCI_IO_END - Au1500_PCI_IO_START + 1);
@@ -94,6 +96,8 @@ static int __init au1x_pci_setup(void)
 	set_io_port_base(virt_io_addr);
 #endif
 
+	au1x_pci_cfg_init();
+
 	register_pci_controller(&au1x_controller);
 	return 0;
 }

arch/mips/kernel/head.S

@@ -136,7 +136,8 @@ EXPORT(_stext)
 	 * kernel load address.  This is needed because this platform does
 	 * not have a ELF loader yet.
 	 */
-	__INIT
+FEXPORT(__kernel_entry)
+	j	kernel_entry
 #endif
 
 	__INIT_REFOK

arch/mips/kernel/time.c

@@ -147,9 +147,9 @@ static __init int cpu_has_mfc0_count_bug(void)
 			return 1;
 
 		/*
-		 * I don't have erratas for newer R4400 so be paranoid.
+		 * we assume newer revisions are ok
 		 */
-		return 1;
+		return 0;
 	}
 
 	return 0;

arch/mips/pci/ops-au1000.c

 /*
  * BRIEF MODULE DESCRIPTION
- *	Alchemy/AMD Au1x00 pci support.
+ *	Alchemy/AMD Au1x00 PCI support.
  *
- * Copyright 2001,2002,2003 MontaVista Software Inc.
+ * Copyright 2001-2003, 2007 MontaVista Software Inc.
  * Author: MontaVista Software, Inc.
  *         	ppopov@mvista.com or source@mvista.com
  *
@@ -69,10 +69,27 @@ void mod_wired_entry(int entry, unsigned long entrylo0,
 	write_c0_pagemask(old_pagemask);
 }
 
-struct vm_struct *pci_cfg_vm;
+static struct vm_struct *pci_cfg_vm;
 static int pci_cfg_wired_entry;
-static int first_cfg = 1;
-unsigned long last_entryLo0, last_entryLo1;
+static unsigned long last_entryLo0, last_entryLo1;
+
+/*
+ * We can't ioremap the entire pci config space because it's too large.
+ * Nor can we call ioremap dynamically because some device drivers use
+ * the PCI config routines from within interrupt handlers and that
+ * becomes a problem in get_vm_area().  We use one wired TLB to handle
+ * all config accesses for all busses.
+ */
+void __init au1x_pci_cfg_init(void)
+{
+	/* Reserve a wired entry for PCI config accesses */
+	pci_cfg_vm = get_vm_area(0x2000, VM_IOREMAP);
+	if (!pci_cfg_vm)
+		panic(KERN_ERR "PCI unable to get vm area\n");
+	pci_cfg_wired_entry = read_c0_wired();
+	add_wired_entry(0, 0, (unsigned long)pci_cfg_vm->addr, PM_4K);
+	last_entryLo0 = last_entryLo1 = 0xffffffff;
+}
 
 static int config_access(unsigned char access_type, struct pci_bus *bus,
 			 unsigned int dev_fn, unsigned char where,
@@ -97,27 +114,6 @@ static int config_access(unsigned char access_type, struct pci_bus *bus,
 			Au1500_PCI_STATCMD);
 	au_sync_udelay(1);
 
-	/*
-	 * We can't ioremap the entire pci config space because it's
-	 * too large. Nor can we call ioremap dynamically because some
-	 * device drivers use the pci config routines from within
-	 * interrupt handlers and that becomes a problem in get_vm_area().
-	 * We use one wired tlb to handle all config accesses for all
-	 * busses. To improve performance, if the current device
-	 * is the same as the last device accessed, we don't touch the
-	 * tlb.
-	 */
-	if (first_cfg) {
-		/* reserve a wired entry for pci config accesses */
-		first_cfg = 0;
-		pci_cfg_vm = get_vm_area(0x2000, VM_IOREMAP);
-		if (!pci_cfg_vm)
-			panic(KERN_ERR "PCI unable to get vm area\n");
-		pci_cfg_wired_entry = read_c0_wired();
-		add_wired_entry(0, 0, (unsigned long)pci_cfg_vm->addr, PM_4K);
-		last_entryLo0  = last_entryLo1 = 0xffffffff;
-	}
-
 	/* Allow board vendors to implement their own off-chip idsel.
 	 * If it doesn't succeed, may as well bail out at this point.
 	 */
@@ -144,9 +140,12 @@ static int config_access(unsigned char access_type, struct pci_bus *bus,
 	/* page boundary */
 	cfg_base = cfg_base & PAGE_MASK;
 
+	/*
+	 * To improve performance, if the current device is the same as
+	 * the last device accessed, we don't touch the TLB.
+	 */
 	entryLo0 = (6 << 26)  | (cfg_base >> 6) | (2 << 3) | 7;
 	entryLo1 = (6 << 26)  | (cfg_base >> 6) | (0x1000 >> 6) | (2 << 3) | 7;
-
 	if ((entryLo0 != last_entryLo0) || (entryLo1 != last_entryLo1)) {
 		mod_wired_entry(pci_cfg_wired_entry, entryLo0, entryLo1,
 				(unsigned long)pci_cfg_vm->addr, PM_4K);

arch/mips/pci/ops-mace.c

@@ -42,6 +42,10 @@ static int
 mace_pci_read_config(struct pci_bus *bus, unsigned int devfn,
 		     int reg, int size, u32 *val)
 {
+	u32 control = mace->pci.control;
+
+	/* disable master aborts interrupts during config read */
+	mace->pci.control = control & ~MACEPCI_CONTROL_MAR_INT;
 	mace->pci.config_addr = mkaddr(bus, devfn, reg);
 	switch (size) {
 	case 1:
@@ -54,6 +58,9 @@ mace_pci_read_config(struct pci_bus *bus, unsigned int devfn,
 		*val = mace->pci.config_data.l;
 		break;
 	}
+	/* ack possible master abort */
+	mace->pci.error &= ~MACEPCI_ERROR_MASTER_ABORT;
+	mace->pci.control = control;
 
 	DPRINTK("read%d: reg=%08x,val=%02x\n", size * 8, reg, *val);
 

arch/mips/pci/pci-ip32.c

@@ -119,6 +119,7 @@ static struct pci_controller mace_pci_controller = {
 	.iommu		= 0,
 	.mem_offset	= MACE_PCI_MEM_OFFSET,
 	.io_offset	= 0,
+	.io_map_base	= CKSEG1ADDR(MACEPCI_LOW_IO),
 };
 
 static int __init mace_init(void)
@@ -135,7 +136,8 @@ static int __init mace_init(void)
 	BUG_ON(request_irq(MACE_PCI_BRIDGE_IRQ, macepci_error, 0,
 			   "MACE PCI error", NULL));
 
-	iomem_resource = mace_pci_mem_resource;
+	/* extend memory resources */
+	iomem_resource.end = mace_pci_mem_resource.end;
 	ioport_resource = mace_pci_io_resource;
 
 	register_pci_controller(&mace_pci_controller);

arch/mips/sgi-ip32/ip32-irq.c

@@ -426,7 +426,6 @@ static void ip32_irq0(void)
 
 	crime_int = crime->istat & crime_mask;
 	irq = MACE_VID_IN1_IRQ + __ffs(crime_int);
-	crime_int = 1 << irq;
 
 	if (crime_int & CRIME_MACEISA_INT_MASK) {
 		unsigned long mace_int = mace->perif.ctrl.istat;

arch/mips/sgi-ip32/ip32-platform.c

@@ -13,21 +13,22 @@
 #include <asm/ip32/mace.h>
 #include <asm/ip32/ip32_ints.h>
 
-/*
- * .iobase isn't a constant (in the sense of C) so we fill it in at runtime.
- */
-#define MACE_PORT(int)							\
+#define MACEISA_SERIAL1_OFFS   offsetof(struct sgi_mace, isa.serial1)
+#define MACEISA_SERIAL2_OFFS   offsetof(struct sgi_mace, isa.serial2)
+
+#define MACE_PORT(offset,_irq)						\
 {									\
-	.irq		= int,						\
+	.mapbase	= MACE_BASE + offset,				\
+	.irq		= _irq,						\
 	.uartclk	= 1843200,					\
 	.iotype		= UPIO_MEM,					\
-	.flags		= UPF_SKIP_TEST,				\
+	.flags		= UPF_SKIP_TEST|UPF_IOREMAP,			\
 	.regshift	= 8,						\
 }
 
 static struct plat_serial8250_port uart8250_data[] = {
-	MACE_PORT(MACEISA_SERIAL1_IRQ),
-	MACE_PORT(MACEISA_SERIAL2_IRQ),
+	MACE_PORT(MACEISA_SERIAL1_OFFS, MACEISA_SERIAL1_IRQ),
+	MACE_PORT(MACEISA_SERIAL2_OFFS, MACEISA_SERIAL2_IRQ),
 	{ },
 };
 
@@ -41,9 +42,6 @@ static struct platform_device uart8250_device = {
 
 static int __init uart8250_init(void)
 {
-	uart8250_data[0].membase = (void __iomem *) &mace->isa.serial1;
-	uart8250_data[1].membase = (void __iomem *) &mace->isa.serial2;
-
 	return platform_device_register(&uart8250_device);
 }